IEEE-C57.106-2002.pdf
《IEEE-C57.106-2002.pdf》由会员分享,可在线阅读,更多相关《IEEE-C57.106-2002.pdf(34页珍藏版)》请在三一文库上搜索。
1、IEEE Std C57.106-2002 (Revision of IEEE Std C57.106-1991) IEEE Standards C57.106 TM IEEE Guide for Acceptance and Maintenance of Insulating Oil in Equipment Published by The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA 8 November 2002 IEEE Power
2、 Engineering Society Sponsored by the Transformers Committee IEEE Standards Print: SH95008 PDF: SS95008 Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=OConnor, Maurice Not for Resale, 04/28/2007 20:
3、23:49 MDTNo reproduction or networking permitted without license from IHS -,-,- Recognized as an American National Standard (ANSI) The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2002 by the Institute of Electrical and Electronics Eng
4、ineers, Inc. All rights reserved. Published 8 November 2002. Printed in the United States of America. Print: ISBN 0-7381-3319-1 SH95008 PDF: ISBN 0-7381-3320-5 SS95008 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written
5、 permission of the publisher. IEEE Std C57.106-2002 (Revision of IEEE Std C57.106-1991) IEEE Guide for Acceptance and Maintenance of Insulating Oil Equipment Sponsor Transformers Committee of the IEEE Power Engineering Society Approved 30 October 2002 American National Standards Institute Approved 1
6、3 June 2002 IEEE-SA Standards Board Abstract: Recommendations regarding oil tests and evaluation procedures are made in this guide; references are made to methods of reconditioning and reclaiming conventional petroleum (mineral) dielectric insulating oils; the levels at which these methods become ne
7、cessary; and the routines for restoring oxidation resistance, where required, by the addition of oxidation inhibitors. The intent is to assist the power equipment operator in evaluating the serviceability of oil received in equipment, oil as received from the supplier for fi lling new equip- ment at
8、 the installation site, and oil as processed into such equipment; and to assist the operator in maintaining oil in serviceable condition. The mineral oil covered is used in transformers, reactors, circuit breakers, load tap changers, and voltage regulators. Keywords: insulation testing, load tap cha
9、ngers, oil circuit breakers, oil insulation, power distribution mainte- nance, power transformer insulation, reactors, transformers, voltage regulators Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User
10、=OConnor, Maurice Not for Resale, 04/28/2007 20:23:49 MDTNo reproduction or networking permitted without license from IHS -,-,- IEEE Standards documents are developed within the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Association (IEEE-SA) Standards Board. The
11、IEEE develops its standards through a consensus develop- ment process, approved by the American National Standards Institute, which brings together volunteers representing varied viewpoints and interests to achieve the fi nal product. Volunteers are not necessarily members of the Institute and serve
12、 with- out compensation. While the IEEE administers the process and establishes rules to promote fairness in the consensus devel- opment process, the IEEE does not independently evaluate, test, or verify the accuracy of any of the information contained in its standards. Use of an IEEE Standard is wh
13、olly voluntary. The IEEE disclaims liability for any personal injury, property or other dam- age, of any nature whatsoever, whether special, indirect, consequential, or compensatory, directly or indirectly resulting from the publication, use of, or reliance upon this, or any other IEEE Standard docu
14、ment. The IEEE does not warrant or represent the accuracy or content of the material contained herein, and expressly disclaims any express or implied warranty, including any implied warranty of merchantability or fi tness for a specifi c purpose, or that the use of the material contained herein is f
15、ree from patent infringement. IEEE Standards documents are supplied “ AS IS .” The existence of an IEEE Standard does not imply that there are no other ways to produce, test, measure, purchase, market, or provide other goods and services related to the scope of the IEEE Standard. Furthermore, the vi
16、ewpoint expressed at the time a standard is approved and issued is subject to change brought about through developments in the state of the art and comments received from users of the standard. Every IEEE Standard is subjected to review at least every fi ve years for revi- sion or reaffi rmation. Wh
17、en a document is more than fi ve years old and has not been reaffi rmed, it is reasonable to conclude that its contents, although still of some value, do not wholly refl ect the present state of the art. Users are cautioned to check to determine that they have the latest edition of any IEEE Standard
18、. In publishing and making this document available, the IEEE is not suggesting or rendering professional or other services for, or on behalf of, any person or entity. Nor is the IEEE undertaking to perform any duty owed by any other person or entity to another. Any person utilizing this, and any oth
19、er IEEE Standards document, should rely upon the advice of a com- petent professional in determining the exercise of reasonable care in any given circumstances. Interpretations: Occasionally questions may arise regarding the meaning of portions of standards as they relate to specifi c applications.
20、When the need for interpretations is brought to the attention of IEEE, the Institute will initiate action to prepare appropriate responses. Since IEEE Standards represent a consensus of concerned interests, it is important to ensure that any interpretation has also received the concurrence of a bala
21、nce of interests. For this reason, IEEE and the members of its soci- eties and Standards Coordinating Committees are not able to provide an instant response to interpretation requests except in those cases where the matter has previously received formal consideration. Comments for revision of IEEE S
22、tandards are welcome from any interested party, regardless of membership affi liation with IEEE. Suggestions for changes in documents should be in the form of a proposed change of text, together with appropriate supporting comments. Comments on standards and requests for interpretations should be ad
23、dressed to: Secretary, IEEE-SA Standards Board 445 Hoes Lane P.O. Box 1331 Piscataway, NJ 08855-1331 USA Authorization to photocopy portions of any individual standard for internal or personal use is granted by the Institute of Electrical and Electronics Engineers, Inc., provided that the appropriat
24、e fee is paid to Copyright Clearance Center. To arrange for payment of licensing fee, please contact Copyright Clearance Center, Customer Service, 222 Rosewood Drive, Danvers, MA 01923 USA; +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE C57 106 2002
链接地址:https://www.31doc.com/p-3771759.html