IEEE-C57.13-2008.pdf
《IEEE-C57.13-2008.pdf》由会员分享,可在线阅读,更多相关《IEEE-C57.13-2008.pdf(94页珍藏版)》请在三一文库上搜索。
1、IEEE Std C57.13-2008 (Revision of IEEE Std C57.13-1993) IEEE Standard Requirements for Instrument Transformers IEEE 3 Park Avenue New York, NY 10016-5997, USA 28 July 2008 IEEE Power Engineering Society Sponsored by the Transformers Committee C57.13 Authorized licensed use limited to: IHS Stephanie
2、Dejesus. Downloaded on October 13, 2008 at 12:37 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 11/15/2008 20:33:15 MSTNo reproductio
3、n or networking permitted without license from IHS -,-,- Authorized licensed use limited to: IHS Stephanie Dejesus. Downloaded on October 13, 2008 at 12:37 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with I
4、EEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 11/15/2008 20:33:15 MSTNo reproduction or networking permitted without license from IHS -,-,- IEEE Std C57.13TM-2008 (Revision of IEEE Std C57.13-1993) IEEE Standard Requirements for Instrument Transformers Sponsor Transformers Co
5、mmittee of the IEEE Power Engineering Society Approved 27 March 2008 IEEE-SA Standards Board Authorized licensed use limited to: IHS Stephanie Dejesus. Downloaded on October 13, 2008 at 12:37 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc.
6、Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 11/15/2008 20:33:15 MSTNo reproduction or networking permitted without license from IHS -,-,- Abstract: Electrical, dimensional, and mechanical characteristics are covered, taking into considera
7、tion certain safety features, for current and inductively coupled voltage transformers of types generally used in the measurement of electricity and the control of equipment associated with the generation, transmission, and distribution of alternating current. The aim is to provide a basis for perfo
8、rmance and interchangeability of equipment covered and to assist in the proper selection of such equipment. Safety precautions are also addressed. Accuracy classes for metering service are provided. The test code covers measurement and calculation of ratio and phase angle, demagnetization, impedance
9、 and excitation measurements, polarity determination, resistance measurements, short-time characteristics, temperature rise tests, dielectric tests, and measurement of open-circuit voltage of current transformers. Keywords: accuracy, current transformer, instrument transformer, primary winding, rate
10、d secondary voltage, routine tests, secondary winding, type tests, voltage transformer The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2008 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published
11、28 July 2008. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. Authorized licensed use lim
12、ited to: IHS Stephanie Dejesus. Downloaded on October 13, 2008 at 12:37 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc. Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 11/15/2008 20:
13、33:15 MSTNo reproduction or networking permitted without license from IHS -,-,- iv Copyright 2008 IEEE. All rights reserved. Introduction This introduction is not part of IEEE Std C57.13-2008, IEEE Standard Requirements for Instrument Transformers. This standard was prepared by the Instrument Transf
14、ormer Subcommittee of the Transformers Committee of the IEEE Power Engineering Society. The purpose of this standard is to cover the electrical, dimensional, and mechanical characteristics and to take into consideration certain safety features, for current and inductively coupled voltage transformer
15、s. The changes in this revision of this standard are to the rated voltage rating of voltage transformers to eliminate the confusion caused by the specification of the primary voltage and the system voltage for line to ground transformers. An addition of partial discharge testing was added to the tes
16、t section. Notice to users Laws and regulations Users of these documents should consult all applicable laws and regulations. Compliance with the provisions of this standard does not imply compliance to any applicable regulatory requirements. Implementers of the standard are responsible for observing
17、 or referring to the applicable regulatory requirements. IEEE does not, by the publication of its standards, intend to urge action that is not in compliance with applicable laws, and these documents may not be construed as doing so. Copyrights This document is copyrighted by the IEEE. It is made ava
18、ilable for a wide variety of both public and private uses. These include both use, by reference, in laws and regulations, and use in private self- regulation, standardization, and the promotion of engineering practices and methods. By making this document available for use and adoption by public aut
19、horities and private users, the IEEE does not waive any rights in copyright to this document. Authorized licensed use limited to: IHS Stephanie Dejesus. Downloaded on October 13, 2008 at 12:37 from IEEE Xplore. Restrictions apply. Copyright The Institute of Electrical and Electronics Engineers, Inc.
20、 Provided by IHS under license with IEEELicensee=IHS Employees/1111111001, User=Japan, IHS Not for Resale, 11/15/2008 20:33:15 MSTNo reproduction or networking permitted without license from IHS -,-,- v Copyright 2008 IEEE. All rights reserved. Updating of IEEE documents Users of IEEE standards shou
21、ld be aware that these documents may be superseded at any time by the issuance of new editions or may be amended from time to time through the issuance of amendments, corrigenda, or errata. An official IEEE document at any point in time consists of the current edition of the document together with a
22、ny amendments, corrigenda, or errata then in effect. In order to determine whether a given document is the current edition and whether it has been amended through the issuance of amendments, corrigenda, or errata, visit the IEEE Standards Association Web site at http:/ieeexplore.ieee.org/xpl/standar
23、ds.jsp, or contact the IEEE at the address listed previously. For more information about the IEEE Standards Association or the IEEE standards development process, visit the IEEE-SA Web site at http:/standards.ieee.org. Errata Errata, if any, for this and all other standards can be accessed at the fo
24、llowing URL: http:/ standards.ieee.org/reading/ieee/updates/errata/index.html. Users are encouraged to check this URL for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. Patents Attention is
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE C57 13 2008
链接地址:https://www.31doc.com/p-3773327.html