IEEE-386-2006.pdf
《IEEE-386-2006.pdf》由会员分享,可在线阅读,更多相关《IEEE-386-2006.pdf(56页珍藏版)》请在三一文库上搜索。
1、IEEE Std 386-2006 (Revision of IEEE Std 386-1995) IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Above 600 V I E E E 3 Park Avenue New York, NY 10016-5997, USA 1 March 2007 IEEE Power Engineering Society Sponsored by the Insulated Conductors Committee IEEE Std
2、 386-2006 (Revision of IEEE Std 386-1995) IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Above 600 V Sponsor Insulated Conductors Committee of the IEEE Power Engineering Society Approved 15 September 2006 IEEE-SA Standards Board -,-,- Abstract: Definitions, se
3、rvice conditions, ratings, interchangeable construction features, and tests are established for loadbreak and deadbreak separable insulated connector systems rated above 600 V and, 600 A or less, for use on power distribution systems. Keywords: deadbreak connector, elbow connector, loadbreak connect
4、or, power distribution systems, separable conductor, separable insulated connector systems _ The Institute of Electrical and Electronics Engineers, Inc. 3 Park Avenue, New York, NY 10016-5997, USA Copyright 2007 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Publ
5、ished 1 March 2007. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy portions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. -,-,- Introduction Th
6、is introduction is not part of IEEE Std 386-2006, IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Above 600 V. This standard was developed in response to a need created by the rapid expansion of underground distribution systems. A key element that allowed this
7、expansion to become a reality is the separable insulated connector. This device provides for simple and inexpensive connection and switching to transformers and other equipment used in underground distribution. When separable insulated connectors became available, the Institute of Electrical and Ele
8、ctronics Engineers (IEEE) and the National Electrical Manufacturers Association (NEMA) worked cooperatively to develop a document that defined the interfaces, ratings, and test conditions for the device. The success of that cooperative effort is apparent from both the vast number of these devices no
9、w in interchangeable use in the field and their enviable safety record. This cooperative effort continues due to the ongoing upgrading and changing nature of these underground systems and products. The recent cooperative effort has been provided by the ANSI C119.2 Subcommittee and the IEEE Working G
10、roup on Separable Connectors under the auspices of the Insulated Conductors Committee of the IEEE Power Engineering Society. This revision reflects the following major additions: Definitions of new and previously omitted connector components Overload current ratings for deadbreak connectors Optional
11、 color coding for 200 A loadbreak connectors Clarification of interchangeability requirements Bushing well stud torque withstand requirement Thermal cycle withstand test for non-elastomeric components Stacking dimensions for 200 A deadbreak and 600 A deadbreak connectors Test table reviewed to indic
12、ate sequence of tests Operating procedures for switching test expanded Trial-use guide for testing separable connector lubricants Operating interface ac withstand test for 200 A loadbreak connectors For information on the application of separable connectors, refer to IEEE Std 1215-2001 B9.a _ a The
13、numbers in brackets correspond to those of the bibliography in Annex C. iv Copyright 2007 IEEE. All rights reserved. -,-,- Notice to users Errata Errata, if any, for this and all other standards can be accessed at the following URL: http:/ standards.ieee.org/reading/ieee/updates/errata/index.html. U
14、sers are encouraged to check this URL for errata periodically. Interpretations Current interpretations can be accessed at the following URL: http:/standards.ieee.org/reading/ieee/interp/ index.html. Patents Attention is called to the possibility that implementation of this standard may require use o
15、f subject matter covered by patent rights. By publication of this standard, no position is taken with respect to the existence or validity of any patent rights in connection therewith. The IEEE shall not be responsible for identifying patents or patent applications for which a license may be require
16、d to implement an IEEE standard or for conducting inquiries into the legal validity or scope of those patents that are brought to its attention. Participants At the time this standard was completed, the NEMA Primary Connector Committee, 8CC-IV, had the following membership: Frank M. Stepniak, Chair
17、Vince A. Baclawski, Secretariat Roy Jazowski John Makal Carl Wentzel Tiebin Zhao At the time this standard was completed, the joint IEEE Power Engineering Society, Insulated Conductors Committee, B16WRevision of IEEE Std 386 Working Group and ANSI C119.2 Subcommittee on Separable Insulated Connector
18、s had the following membership: Frank M. Stepniak, Chair Harry Hayes, Vice Chair Vince A. Baclawski, Secretariat Darren Barnett Ed Bradley Dave Britton Thomas Champion Jack Cherry Russ Dantzler Robert Gear Stan Heyer Trung Hiu Stan Howell Roy Jazowski Gael Kennedy Albert Kong Glenn Luzzi John Makal
19、Greg Mastoras Rachel Mosier Denis Pratt Ewell (Tim) Robeson Roger Schoneman Bruce Shattuck John Spence Wes Spencer Greg Stano Tim Wall Dennis Wedam Carl Wentzel Sanford Yoder Tiebin Zhao v Copyright 2007 IEEE. All rights reserved. -,-,- vi Copyright 2007 IEEE. All rights reserved. The following memb
20、ers of the individual balloting committee voted on this standard. Balloters may have voted for approval, disapproval, or abstention. Marcos Andrade Kenneth Bow Harvey Bowles Vern Buchholz William Byrd Thomas Callsen Mary Capelli-Schellpfeffer Michael Clodfeder R. Daubert Larry Davis Frank Denbrock J
21、ohn Densley Mark Drabkin John DuPont Dana Dufield Guru Dutt Dhingra Stephen Early Marcia Eblen Gary Engmann Michael Faulkenberry Jorge Fernandez-Daher Marcel Fortin Robert Fulcomer Robert Gear David Gilmer Ron Greenthaler Randall Groves Richie Harp Jeffrey Hartenberger Steven Hensley Dennis Horwitz
22、David Jackson Edward Jankowich Robert Keefe Gael R. Kennedy Yuri Khersonsky Hermann Koch Edwin Kramer Gregory Luri Glenn Luzzi John Makal James Medek Steven Meiners John Merando G. Michel Shantanu Nandi Gary L. Nissen Neal Parker Michael Pehosh Dave Singleton Michael Smalley James Smith Gregory Stan
23、o Brian Steinbrecher Frank M. Stepniak John Teixeira William Thue Carl Wall Daniel Ward Lee Welch Carl Wentzel James Wilson Jan Zawadzki Tiebin Zhao Donald W. Zipse When the IEEE-SA Standards Board approved this standard on 15 September 2006, it had the following membership: Steve M. Mills, Chair Ri
24、chard H. Hulett, Vice Chair Don Wright, Past Chair Judith Gorman, Secretary Mark D. Bowman Dennis B. Brophy William R. Goldbach Arnold M. Greenspan Robert M. Grow Joanna N. Guenin Julian Forster* Mark S. Halpin Kenneth S. Hanus William B. Hopf Joseph L. Koepfinger* David J. Law Daleep C. Mohla T. W.
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- IEEE 386 2006
链接地址:https://www.31doc.com/p-3773387.html