ISO-10485-1991.pdf
《ISO-10485-1991.pdf》由会员分享,可在线阅读,更多相关《ISO-10485-1991.pdf(5页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD IS0 10485 First edition 1991-12-01 Cone proof load test on nuts Essai de charge d t5preuve au cbne des dcrous Reference number IS0 10485:1991(E) Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/
2、9972545001 Not for Resale, 04/28/2007 06:50:59 MDTNo reproduction or networking permitted without license from IHS -,-,- IS0 10485:1991(E) Foreword IS0 (the international Organization for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies). The work of prepari
3、ng international Standards is normally carried out through IS0 technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. international organizations, govern- mental and non-governmental, in l
4、iaison with ISO, also take part in the work. IS0 collaborates closely with the international Eiectrotechnicai Commission (IEC) on ail matters of eiectrotechnicai standardization. Draft international Standards adopted by the technical committees are circulated to the member bodies for voting. Publica
5、tion as an inter- national Standard requires approval by at least 75 % of the member bodies casting a vote. international Standard IS0 10485 was prepared by Technical Committee iSO/TC 2, Fasteners, Sub-Committee SC 1, Mechanical properties of fasteners. 8 IS0 1991 All rlghts reserved. No part of thl
6、s publication may be reproduced or utilized in any form or by any means, electronic or mechanical, Including photocopying and mlcrofllm, without permlsslon In writing from the publlsher. International Organlzatlon for Standardlzatlon Case Postale 56 l CH-1211 Genkve 20 l Swltzerland Printed In Switz
7、erland ii Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/28/2007 06:50:59 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD IS0 10485:1991
8、(E) Cone proof load test on nuts 1 Scope This international Standard specifies the properties of - - - nuts with nominal thread diameter, d, from 5 mm up to and including 39 mm, product grades A and B, property classes 8 to 12, under the conditions of the cone proof load test. 2 Normative references
9、 The following standards contain provisions which, through reference in this text, constitute provisions of this international Standard. At the time of pubii- cation, the editions indicated were valid. Ail stan- dards are subject to revision, and parties to agreements based on this international Sta
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 10485 1991
链接地址:https://www.31doc.com/p-3773779.html