ISO-105-B08-1995.pdf
《ISO-105-B08-1995.pdf》由会员分享,可在线阅读,更多相关《ISO-105-B08-1995.pdf(12页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD ISO 105-BOB First edition 1995-06-01 Textiles k Tests for colour fastness - Part B08: Quality control of blue wo01 reference materials 1 to 7 Textiles - Essais de solidite des teintures - Partie B08: Mai trise de Ia qualit6 des matkiaux de reference 7 8 7 de Iahe teinte en ble
2、u Reference number ISO 105-B08: 1995(E) Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/23/2007 20:48:27 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 105
3、-B08:1995(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national Standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Esch member body interested in a subject
4、for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) o
5、n all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard
6、 ISO 105-B08 was prepared by Technical Committee lSO/TC 38, Textiles, Subcommittee SC 1, Tests for coloured textiles and coloran ts. ISO 105 was previously published in thirteen “Parts”, each designated by a letter (e.g. “Part A”), with publication dates between 1978 and 1985. Esch part contained a
7、series of “sections”, each designated by the re- spective part letter and by a two-digit serial number (e.g. “Section AO1 “). These sections are now being republished as separate documents, them- selves designated “Parts” but retaining their earlier alphanumeric desig- nations. A complete list of th
8、ese Parts is given in ISO 105-AOI . Annexes A and B of this part of ISO 105 are for information only. 0 ISO 1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronie or mechanical, including photocopying an
9、d microfilm, without Permission in writing from the publisher. International Organization for Standardization Case Postale 56 l CH-l 211 Geneve 20 l Switzerland Printed in Switzerland Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Techni
10、cal Standards 1/9972545001 Not for Resale, 04/23/2007 20:48:27 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD 0 ISO ISO 1050B08:1995(E) Textiles - Tests for colour fastness - Part B08: Ouality control of blue wo01 reference materials 1 to 7 1 Scope T
11、his part of ISO 105 describes a method for carrying out quality control of production batches of the blue wool reference materials 1 to 7 which are to be used in the appropriate Parts of ISO 105-B series of test methods for colour fastness to light. The method specifies one procedure for instrumenta
12、l assessment of the evenness of dyeing and two pro- cedures for assessing the fading characteristics of the reference materials, one of which uses visual as- sessment techniques and the other instrumental as- sessment. The characteristics of the reference material(s) under test then are compared wit
13、h the characteristics of master reference material(s). The method is applicable to all dyed wool fabrics in- tended for use as reference materials 1 to 7 (see ISO 105-BOI :1994, subclause 4.1 .l). NOTES 1 This method is not suitable for blue wo01 reference 8, since the time required to fade to grey
14、scale 4 and grey scale 3 contrasts would be inordinately long. An alternative method is under consideration for application to blue wool reference 8. 2 The method given is based on ISO 105-B02, which is considered internationally to be the most widely employed method for testing colour fastness to l
15、ight and to be rep- resentative of all methods where the use of blue wool ref- erences is specified. 3 Information on levels of acceptance and storage con- ditions is given in annexes A and B respectively. 2 Normative references The following Standards contain provisions which, through reference in
16、this text, constitute provisions of this part of ISO 105. At the time of publication, the editions indicated were valid. All Standards are subject to revision, and Parties to agreements based on this part of ISO 105 are encouraged to investigate the possibility of applying the most recent editions o
17、f the Standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 105-AO1 :1994, Textiles - Tests for colour fast- ness - Part AOI: General principles of testing. ISO 105-A02:1993, Textiles - Tests for colour fast- ness - Part A02: Grey scale
18、for assessing Change in colour. ISO 105-BOI :1994, Textiles - Tests for colour fast- ness - Part BOI: Colour fastness to light: Daylight. ISO 105-B02:1994, Textiles - Tests for colour fast- ness - Part B02: Colour fastness to artificial Iight: Xenon arc fading /amp test. ISO 105-J03:19951), Textiles
19、 - Tests for colour fast- ness - Part J03: Calculation of colour differentes. 1) To be published. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/23/2007 20:48:27 MDTNo reproduction or n
20、etworking permitted without license from IHS -,-,- ISO 105-B08:1995(E) 0 ISO 3 Principle Spetimens from the reference material under test are examined as follows: a) spectrophotometric assessment of the evenness of dyeing; b) visual assessment of the fading characteristics in comparison with the app
21、ropriate master reference material (see 4.7); c) spectrophotometric assessment of the fading characteristics. 4 Apparatus 4.1 Spectrophotometer, capable of measuring re- flectance values over the visible wavelength range 400 nm to 700 nm of samples of a size relevant to the test method (see 6.2.1).
22、4.2 Computer and associated Software, capable of calculating colour differentes in accordance with the conditions specified in 6.1.2 and 6.2.2 . 4.3 Fading apparatus, containing a Xenon arc light Source capable of operating under conditions speci- fied in ISO 105-B02:1994, subclause 4.2.1. 4.4 Opaqu
23、e cover, of cardboard or other thin opaque material (see ISO 105-B02: 1994, subclause 4.2.2). 4.5 Black-Panel thermometer (see ISO 105-B02: 1994, subclause 4.2.3.1). NOTE 4 Black-Panel thermometers are available from the manufacturers of fading apparatus. 4.6 Humidity test control (see ISO 105-B02:1
24、994, subclause 4.1.3). NOTE 5 For information on the sources of supply of hu- midity test controls, see ISO 105-AOl:l994, clause 8, note 1. 4.7 Master reference material, appropriate to the material under test. Sets of master reference materials are held in several countries for reference. 4.8 Grey
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 105 B08 1995
链接地址:https://www.31doc.com/p-3773836.html