ISO-10536-3-1996.pdf
《ISO-10536-3-1996.pdf》由会员分享,可在线阅读,更多相关《ISO-10536-3-1996.pdf(25页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD ISO/IEC 10536-3 First edition 1996-l 2-01 Identification cards - Contactless integrated circuit(s) cards - Part 3: Electronic signals and reset procedures Cartes didentification - Cartes B circuitfsl int6grW sans contact - Partie 3: Signaux blectroniques et procedures de rkini
2、tialisation Reference number ISO/IEC 10536-3:1996(E) Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 21:25:22 MDTNo reproduction or networking permitted without license from IHS
3、-,-,- ISOAEC 10536-3: 1996(E) Contents Foreword . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii Introduc
4、tion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iv 1 Scope . 1 2 Normative references 1 3 Definitions,
5、abbreviations and symbols 2 4 Operating sequence for contactless integrated circuit(s) cards . 2 5 Power Transfer 2 6 Communications 3 7 Conditions for reset of the WCC 5 8 Conditions after reset . 6 Annexes A Test methods for power transfer 7 B Test methods for capacitive data transfer 9 C Test met
6、hods for inductive data transfer . 11 D Test elements and setup 13 0 ISO/IEC 1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission
7、 in writing from the publisher. ISO/IEC Copyright Office l Case postale 56 l CH-1211 Geneve 20 l Switzerland Printed in Switzerland ii Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/
8、2007 21:25:22 MDTNo reproduction or networking permitted without license from IHS -,-,- 0 ISOAEC ISOAEC 10536-3: 1996(E) Foreword IS0 (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization
9、. National bodies that are members of IS0 or IEC participate in the development of International Standards through technical committees established by the respective organizations to deal with particular fields of technical activity. IS0 and IEC technical committees collaborate in fields of mutual i
10、nterest. Other international organizations, governmental and non-governmental, in liaison with IS0 and IEC, also take part in the work. In the field of information technology, IS0 and IEC have established a joint technical committee, ISO/IEC JTC 1. Draft International Standards adopted by the joint
11、technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75% of the national bodies casting a vote. International Standard ISO/IEC 10536-3 was prepared by Joint Technical Committee ISO/IEC JTC 1, information technology,
12、Subcommittee SC 17, Identification cards and related devices. ISO/IEC 10536 consists of the following parts, under the general title Identification cards - Contactless integrated circuit(s) cards: - Part 1: Physical characteristics - Part 2: Dimensions and locations of coupling areas - Part 3: Elect
13、ronic signals and reset procedures Annexes A to D form an integral part of this part of ISO/lEC 10536. III Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 21:25:22 MDTNo reproduc
14、tion or networking permitted without license from IHS -,-,- ISOAEC 10536-3: 1996(E) 0 ISOAEC Introduction ISO/IEC 10536 is one of a series of International Standards describing the parameters for identification cards as defined in IS0 7810 and the use of such cards for international interchange. Thi
15、s part of ISO/IEC 10536 describes the electronic characteristics of the contactless interface between a contactless integrated circuit(s) card and a card-coupling device. The interfaces include power and bi-directional communications. Copyright International Organization for Standardization Provided
16、 by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 21:25:22 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD 0 ISO/IEC lSO/lEC 10536-3: 1996(E) Identification cards - Contactless integrated circuit(
17、s) cards - Part 3: Electronic signals and reset procedures 1 Scope This part of ISO/IEC 10536 specifies the nature and characteristics of the fields to be provided for power and bi-directional communications between card coupling devices (CCDs) and contactless integrated circuit(s) cards (CICCs) of
18、the ID-1 card type in slot or surface operation. This part of ISO/IEC 10536 does not specify the means of generating coupling fields, nor the means of compliance with electromagnetic radiation regulations. This part of ISO/IEC 10536 is to be used in conjunction with ISO/IEC 10536-I and ISO/IEC 10536
19、-2. NOTE 1 Other types of contactless integrated circuit(s) cards, formats or interfaces, which operate at various distances, may be developed in the future, which may call for additions to be made to this part of ISO/IEC 10536 or may require other International Standards to be written. 2 Normative
20、references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of ISO
21、/IEC 10536 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and IS0 maintain registers of currently valid International Standards. IS0 1177: 1985, Information processing - Character structure for start/stop and synchr
22、onous character oriented transmission. IS0 7810: 1985, Identification cards - Physical characteristics. ISO/IEC 781 l-l : 1995, Identification cards - Recording technique - Part 1: Embossing. ISO/IEC 781 l-2: 1995, identification cards - Recording technique - Part 2: Magnetic Stripe. ISO/IEC 7811-3:
23、 1995, identification cards - Recording technique - Part 3: Location of embossed characters on ID- 1 cards. ISO/IEC 781 l-4: 1995, identification cards - Recording technique - Part 4: Location of read-only magnetic tracks - Tracks 1 and 2. ISO/IEC 781 l-5: 1995, identification cards - Recording tech
24、nique - Part 5: Location of read-write magnetic track - Track 3. ISO/IEC 7812-I : 1993, Identification cards - identification of issuers - Part 7: Numbering system. ISO/IEC 7812-2: 1993, identification cards - Identification of issuers - Part 2: Application and registration procedures. IS0 7813: 198
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 10536 1996
链接地址:https://www.31doc.com/p-3773868.html