ISO-10591-2005.pdf
《ISO-10591-2005.pdf》由会员分享,可在线阅读,更多相关《ISO-10591-2005.pdf(10页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 10591:2005(E) ISO 2005 INTERNATIONAL STANDARD ISO 10591 Second edition 2005-07-01 Building construction Sealants Determination of adhesion/cohesion properties of sealants after immersion in water Construction immobilire Produits pour joints Dtermination des proprits dadhsivit/c
2、ohsion des mastics aprs immersion dans leau Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 19:19:51 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO
3、 10591:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In download
4、ing this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the Gen
5、eral Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address give
6、n below. ISO 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member
7、body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2005 All rights reserved Copyright International Organization for Standardization Provided
8、 by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 19:19:51 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 10591:2005(E) ISO 2005 All rights reserved iii Contents Page Foreword iv 1 Scope . 1 2 Normative references.
9、 1 3 Terms and definitions. 1 4 Principle. 1 5 Apparatus 1 6 Preparation of test specimens 2 7 Conditioning of test specimens 2 8 Test procedure 3 9 Expression of results . 3 10 Test report . 3 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=N
10、ASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 19:19:51 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 10591:2005(E) iv ISO 2005 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national
11、 standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. Internationa
12、l organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules
13、given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at lea
14、st 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 10591 was prepared by Technical Committee ISO/TC 59,
15、 Building construction, Subcommittee SC 8, Jointing products. This second edition cancels and replaces the first edition (ISO 10591:1991), Clauses 2, 5, 6, and 7 of which have been technically revised. Copyright International Organization for Standardization Provided by IHS under license with ISO Li
16、censee=NASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 19:19:51 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 10591:2005(E) ISO 2005 All rights reserved 1 Building construction Sealants Determination of adhesion/cohesion propert
17、ies of sealants after immersion in water 1 Scope This International Standard specifies a method for the determination of the influence of water on the adhesion cohesion properties of sealants with predominantly plastic behaviour which are used in joints in building construction. 2 Normative referenc
18、es The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 6927, Building construction Jointing produ
19、cts Sealants Vocabulary ISO 13640, Building construction Jointing products Specifications for test substrates 3 Terms and definitions For the purposes of this document, the definitions given in ISO 6927 apply. 4 Principle Test specimens are prepared in which the sealant to be tested adheres to two p
20、arallel contact surfaces. After submission of the test specimens to water immersion under defined conditions, the test specimens are extended to rupture and the elongation at break recorded. 5 Apparatus 5.1 Substrate materials, used for the preparation of test specimens, are defined in ISO 13640, Sp
21、ecification for test substrates. The substrate materials shall be selected from mortar and/or anodized aluminium and/or glass. Other substrate materials may be used as agreed by the parties concerned. For each test specimen, two substrate pieces of the same material are required, with a cross-sectio
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 10591 2005
链接地址:https://www.31doc.com/p-3773906.html