ISO-10911-1994.pdf
《ISO-10911-1994.pdf》由会员分享,可在线阅读,更多相关《ISO-10911-1994.pdf(5页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD IS0 10911 First edition 1994-l I-1 5 Solid hardmetal end mills with parallel shank - Dimensions Fraises cylindriques deux tail/es monobloc en mktaux-durs - Dimensions Reference number IS0 10911 :I 994(E) Copyright International Organization for Standardization Provided by IHS
2、under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/28/2007 04:58:21 MDTNo reproduction or networking permitted without license from IHS -,-,- IS0 10911:1994(E) Foreword IS0 (the International Organization for Standardization) is a worldwide federation of nationa
3、l standards bodies (IS0 member bodies). The work of preparing International Standards is normally carried out through IS0 technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. Internation
4、al organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. IS0 collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committee
5、s are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard IS0 10911 was prepared by Technical Committee lSO/TC 29, Small too/s, Subcommittee SC 9, Tools with cutting edges
6、made of hard cutting materials. 0 IS0 1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. Interna
7、tional Organization for Standardizatron Case Postale 56 l CH-1211 Geneve 20 . Switzerland Printed in Switzerland ii Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/28/2007 04:58:21 MDTNo
8、 reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD 8 IS0 IS0 10911:1994(E) Solid hardmetal end mills with parallel shank - Dimensions 1 Scope This International Standard specifies the dimensions of solid hardmetal end mills with parallel shank. The designatio
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 10911 1994
链接地址:https://www.31doc.com/p-3774061.html