ISO-1098-1975.pdf
《ISO-1098-1975.pdf》由会员分享,可在线阅读,更多相关《ISO-1098-1975.pdf(4页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD. 1098 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION l MEXAYHAPOAHM OPTAHM3ALW-l I-IO CTAHAAPTM3AWMORGANISATION INTERNATIONALE DE NORMALISATION Veneer plywood for general use - General requirements Contreplaque B plis d/usage gen these documents are now in the process of being
2、 transformed into International Standards. As part of this process, Technical Committee ISO/TC 139 has reviewed IS0 Recommendation R 1098 and found it technically suitable for transformation. International Standard IS0 1098 therefore replaces IS0 Recommendation R 1098-1969 to which it is technically
3、 identical. IS0 Recommendation R 1098 was approved by the Member Bodies of the following countries: Australia Austria Colombia Czechoslovakia Egypt, Arab Rep. of Finland France Germany Hungary The Member Body of the following Recommendation on technical grounds: India Iran Israel Italy Netherlands N
4、ew Zealand Norway Peru Poland country Portugal Romania South Africa, Rep. of Spain Sweden Switzerland Thailand Turkey United Kingdom expressed disapproval of the The Member Bodies of the following countries disapproved the transformation of lSO/R 1098 into an International Standard: Canada Itaty 0 I
5、nternational Organization for Standardization, 1975 l Printed in Switzerland Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/25/2007 22:13:56 MDTNo reproduction or networking permitted w
6、ithout license from IHS -,-,- INTERNATIONAL STANDARD IS0 10984975 (E) Veneer plywood for general use - General requirements 1 SCOPE This International Standard specifies the general re- quirements for veneer plywood panels for general use, defined in IS0 2074. 2 FIELD OF APPLICATION This Internation
7、al Standard applies to flat veneer plywood panels, composed of at least three plies. It does not concern panels covered with decorative veneers, faced panels and panels for special use. In the normal dry condition, no outer ply shall have a thickness greater than 3,5 mm and no inner ply shall have a
8、 thickness greater than 5 mm. However, for coniferous plywood the thickness of the inner and outer plies shall not exceed 6,5 mm. 5 MOISTURE CONTENT When the panels leave the shall be between 6 and 14 % 6 WORKMANSHIP factory the moisture content The panels shall be rectangular with straight edges an
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 1098 1975
链接地址:https://www.31doc.com/p-3774063.html