ISO-11077-1993.pdf
《ISO-11077-1993.pdf》由会员分享,可在线阅读,更多相关《ISO-11077-1993.pdf(12页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD IS0 11077 First edition 1993-07-01 Aerospace - Self-propelled de-icing/anti-icing vehicles - Functional requirements Abronautique et espace - Vbhicules automoteurs de dkgivrage/antigivrage des akronefs - Exigences fonctionnelles “ The American National Standards Institute (ANS
2、I) is the primary source and official sales agent for IS0 standards in the United States ANSI was granted an exclusive license to distribute and sell IS0 standards, technical reports, drafts and other priced publications within the U S A Under this license agreement IS0 has granted to ANSI the right
3、 to reproduce IS0 standards and drafts within the territories of the United States” Reference number IS0 I 10771993(E) Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/23/2007 21:43:07 MD
4、TNo reproduction or networking permitted without license from IHS -,-,- IS0 11077:1993(E) Contents Page Scope 1 Normative references . 1 General requirements 1 Design and overall dimensions . 2 Mobility and stability . 3 Controls . 3 Quality assurance 3 Annex A Bibliography . . . . . . . . . . . . .
5、 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 0 IS0 1993 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying
6、 and microfilm, without per- mission in writing from the publisher International Organization for Standardization Case Postale 56 ? CH-1211 Geneve 20 ? Switzerland Printed in Switzerland ii Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA
7、Technical Standards 1/9972545001 Not for Resale, 04/23/2007 21:43:07 MDTNo reproduction or networking permitted without license from IHS -,-,- IS0 11077:1993(E) Foreword IS0 (the International Organization for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies
8、). The work of preparing International Standards is normally carried out through IS0 technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and no
9、n-governmental, in liaison with ISO, also take part in the work. IS0 collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies
10、 for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard IS0 11077 was prepared by Technical Committee ISO/TC 20, Aircraft and space vehicles, Sub-Committee SC 9, Air cargo and ground equipment. Annex A of th
11、is International Standard is for information only. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/23/2007 21:43:07 MDTNo reproduction or networking permitted without license from IHS -,
12、-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/23/2007 21:43:07 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD IS0 11077:1993(E) Ae
13、rospace - Self-propelled de-icing/anti-icing vehicles - Functional requirements 1 Scope This International Standard specifies the general functional and performance requirements for a self- propelled, boom type aerial device, equipped with an aircraft de-icing/anti-icing fluid (ADF) spraying system.
14、 This International Standard does not specify a com- prehensive set of technical design criteria for aircraft de-icing/anti-icing vehicles, but only those relating to functional and performance requirements. 2 Normative references The following standards contain provisions which, through reference i
15、n this text, constitute provisions of this International Standard. At the time of publi- cation, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most
16、 re- cent editions of the standards indicated below. Members of IEC and IS0 maintain registers of cur- rently valid International Standards. IS0 6966:1982, Aircraft - Basic requirements for aircraft loading equipment. IS0 7000:1989, Graphical symbols for use on equip- ment - Index and synopsis. 3 Ge
17、neral requirements 3.1 Basic requirements The basic requirements of IS0 6966 shall be met. NOTE 1 Although a de-icing/anti-icing vehicle is not a piece of aircraft loading equipment, the basic general re- quirements are identical for aircraft loading and aircraft ser- vicing equipment, designed in t
18、he same airport ramp environment. 3.2 Equipment The vehicle shall be large enough to accommodate the fluid capacity required for narrow-body and wide- body aircraft and may be chosen by the purchaser from the alternatives given in table 1. Table 1 Tank capacity Minimum basket-to- floor height gaNU.S
19、) m ft The unit shall consist of the following: a) a suitable self-propelled chassis; b) an aerial device with personnel basket constructed and mounted in accordance with applicable na- tional safety standards; c) fluid supply tank(s); d) a fluid pumping system and heater for applying heated de-icin
20、g fluid to aircraft surfaces. 3.3 Basic performance features 3.3.1 The primary function of the vehicle shall be to apply heated de-icing/anti-icing fluid and their mixtures from a variable height boom to the surfaces of stationary aircraft while traversing their perimeter. A hose stored in a compart
21、ment shall also be fitted for ground use. The vehicle shall be acceptable for use around terminal gate areas, airport service roads and aircraft service ramps. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/99725450
22、01 Not for Resale, 04/23/2007 21:43:07 MDTNo reproduction or networking permitted without license from IHS -,-,- IS0 11077:1993(E) 3 , 3.3.2 The personnel basket shall have the minimum lift capacity given in table 2. 4.3 The maximum width shall be 2,5 m and the maximum height in the lowered boom pos
23、ition shall be 3,8 m. Table 2 Minimum lift capacity kg I lb 4.4 Tow hooks shall be installed on the chassis structure, with at least two at the front and one at the rear. A size 136 300 6 size 204 450 4.5 Storage batteries shall be of the heavy duty type. The vehicle electrical system shall be based
24、 on 12 V d.c. or 24 V d.c. power. 3.3.3 The de-icing fluid system shall be capable of a delivery rate at the personnel basket spray nozzle of at least 190 I/min 50 gal(US)/min at a prenozzle dis- charging pressure of 655 kPa (95 psi), with the boom fully elevated. 3.3.4 The de-icing fluid system sha
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 11077 1993
链接地址:https://www.31doc.com/p-3774065.html