ISO-11073-30300-2004.pdf
《ISO-11073-30300-2004.pdf》由会员分享,可在线阅读,更多相关《ISO-11073-30300-2004.pdf(72页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD ISO/IEEE 11073-30300 First edition 2004-12-15 Reference number ISO/IEEE 11073-30300:2004(E) ISO/IEEE 2004 Health informatics Point-of-care medical device communication Part 30300: Transport profile Infrared wireless Informatique de sant Communication entre dispositifs mdicaux
2、sur le site des soins Partie 30300: Profil de transport Faisceau infrarouge Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 22:57:56 MDTNo reproduction or networking permit
3、ted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 22:57:56 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IE
4、EE 11073-30300:2004(E) Health informatics Point-of-care medical device communication Part 30300: Transport profile Infrared wireless Sponsor IEEE 1073 Standard Committee of the IEEE Engineering in Medicine and Biology Society Approved 24 June 2004 IEEE-SA Standards Board Copyright International Orga
5、nization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 22:57:56 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEEE 11073-30300:2004(E) iiCopyright 2004 ISO/IEEE. All rights re
6、served. PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the com- puter performing the editing. In downloading t
7、his file, parties accept therein the responsibility of not infringing Adobes licensing policy. Neither the ISO Central Secretariat nor the IEEE accepts any liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be
8、 found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies and IEEE members. In the unlikely event that a problem relating to it is found, please inform the ISO C
9、entral Secretariat or the IEEE at the address given below. Abstract: This standard establishes a connection-oriented transport profile and physical layer suitable for medical device communications that use short-range infrared wireless. This standard defines communications services and protocols tha
10、t are consistent with specifications of the Infrared Data Association (IrDA) and are optimized for point-of-care (POC) applications at or near the patient. Keywords: access point, bedside, device interfaces, infrared, Infrared Data Association, IrDA, legacy device, medical device, medical device com
11、munications, medical information bus, MIB, patient, Simple Network Time Protocol, SNTP, point-of-care, POC, point-of-care testing, POCT, wireless This ISO/IEEE document is an International Standard and is copyright-protected by ISO and the IEEE. Except as permitted under the applicable laws of the u
12、sers country, neither this ISO/IEEE standard nor any extract from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce shou
13、ld be addressed to either ISO or the IEEE at the addresses below. ISO copyright officeInstitute of Electrical and Electronics Engineers Case postale 56 CH-1211 Geneva 20Standards Association Tel. + 41 22 749 01 11Manager, Standards Intellectual Property Fax + 41 22 749 09 47445 Hoes Lane E-mail copy
14、rightiso.orgPiscataway, NJ 08854 Web www.iso.orgE-mail: stds.iprieee.org Web: www.ieee.org Copyright 2004 ISO/IEEE. All rights reserved. Published 15 December 2004. Printed in the United States of America. IEEE is a registered trademark in the U.S. Patent +1 978 750 8400. Permission to photocopy por
15、tions of any individual standard for educational classroom use can also be obtained through the Copyright Clearance Center. NOTE Attention is called to the possibility that implementation of this standard may require use of subject matter covered by patent rights. By publication of this standard, no
16、 position is taken with respect to the exist- ence or validity of any patent rights in connection therewith. The IEEE shall not be responsible for identifying patents for which a license may be required by an IEEE standard or for conducting inquiries into the legal valid- ity or scope of those paten
17、ts that are brought to its attention. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 22:57:56 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO
18、/IEEE 11073-30300:2004(E) ivCopyright 2004 ISO/IEEE. All rights reserved. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 04/04/2007 22:57:56 MDTNo reproduction or networking permitte
19、d without license from IHS -,-,- ISO/IEEE 11073-30300:2004(E) Copyright 2004 ISO/IEEE. All rights reserved.v ISO Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards
20、 is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take p
21、art in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Sta
22、ndard requires approval by at least 75% of the member bodies casting a vote. A pilot project between ISO and the IEEE has been formed to develop and maintain a group of ISO/IEEE standards in the field of medical devices as approved by Council resolution 43/2000. Under this pilot project, IEEE is res
23、ponsible for the development and maintenance of these standards with participation and input from ISO member bodies. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. Neither ISO nor the IEEE shall be held responsible
24、for identifying any or all such patent rights. ISO/IEEE 11073-30300:2004(E) was prepared by IEEE 1073 Committee of the IEEE Engineering in Medicine and Biology Society. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001,
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 11073 30300 2004
链接地址:https://www.31doc.com/p-3774120.html