ISO-12217-1-2002.pdf
《ISO-12217-1-2002.pdf》由会员分享,可在线阅读,更多相关《ISO-12217-1-2002.pdf(54页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 12217-1:2002(E) ISO 2002 INTERNATIONAL STANDARD ISO 12217-1 First edition 2002-04-01 Small craft Stability and buoyancy assessment and categorization Part 1: Non-sailing boats of hull length greater than or equal to 6 m Petits navires valuation et catgorisation de la stabilit e
2、t de la flottabilit Partie 1: Bateaux propulsion non vlique dune longueur de coque suprieure ou gale 6 m Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 01:58:02 MDTNo reproducti
3、on or networking permitted without license from IHS -,-,- ISO 12217-1:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to an
4、d installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the softwar
5、e products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is f
6、ound, please inform the Central Secretariat at the address given below. ISO 2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission
7、in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.ch Web www.iso.ch Printed in Switzerland ii ISO 2002 All rights reserved Copyri
8、ght International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 01:58:02 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 12217-1:2002(E) ISO 2002 All rights reserved iii
9、Contents Page Foreword.iv Introduction.v 1 Scope1 2 Normative references1 3 Terms and definitions .2 3.1 Primary2 3.2 Downflooding.3 3.3 Dimensions, areas and angles.4 3.4 Condition, mass and volume5 3.5 Other terms and definitions6 4 Symbols8 5 Procedure.8 5.1 Maximum total load.8 5.2 Sailing or no
10、n-sailing8 5.3 Tests and calculations to be applied.8 6 Tests, calculations and requirements.10 6.1 Downflooding.10 6.2 Offset-load test 14 6.3 Resistance to waves and wind (design categories A and B only) .15 6.4 Heel due to wind action (design categories C and D only).16 6.5 Flotation requirements
11、17 7 Application .17 7.1 Deciding the design category 17 7.2 Meaning of the design categories (see Table 5) .17 Annex A (normative) Full method for required downflooding height .18 Annex B (normative) Method for offset-load test 20 Annex C (normative) Methods for calculating downflooding angle24 Ann
12、ex D (normative) Determining the curve of righting moments26 Annex E (normative) Method for level flotation test28 Annex F (normative) Flotation material and elements32 Annex G (normative) Information for owners manual34 Annex H (informative) Summary of requirements .35 Annex I (informative) Workshe
13、ets .36 Bibliography47 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 01:58:02 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 12217-1:2002(E) iv I
14、SO 2002 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body intereste
15、d in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Com
16、mission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the techni
17、cal committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of ISO 12217 may be the subject of patent right
18、s. ISO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 12217-1 was prepared by Technical Committee ISO/TC 188, Small craft. ISO 12217 consists of the following parts, under the general title Small craft Stability and buoyancy assessment and cat
19、egorization: Part 1: Non-sailing boats of hull length greater than or equal to 6 m Part 2: Sailing boats of hull length greater than or equal to 6 m Part 3: Boats of hull length less than 6 m Annexes A, B, C, D, E, F and G form a normative part of this part of ISO 12217. Annexes H and I are for info
20、rmation only. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 01:58:02 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 12217-1:2002(E) ISO 2002 All
21、rights reserved v Introduction This part of ISO 12217 enables the determination of the limiting environmental conditions for which an individual boat has been designed. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1
22、/9972545001 Not for Resale, 04/07/2007 01:58:02 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/07/2007 01:58:02
23、 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 12217-1:2002(E) ISO 2002 All rights reserved 1 Small craft Stability and buoyancy assessment and categorization Part 1: Non-sailing boats of hull length greater than or equal to 6 m CAUTION Complian
24、ce with this part of ISO 12217 does not guarantee total safety or total freedom of risk from capsize or sinking. 1 Scope This part of ISO 12217 specifies methods for evaluating the stability and buoyancy of intact (i.e. undamaged) boats. The flotation characteristics of boats vulnerable to swamping
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 12217 2002
链接地址:https://www.31doc.com/p-3774384.html