ISO-1181-2004.pdf
《ISO-1181-2004.pdf》由会员分享,可在线阅读,更多相关《ISO-1181-2004.pdf(12页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 1181:2004(E) ISO 2004 INTERNATIONAL STANDARD ISO 1181 Third edition 2004-11-01 Fibre ropes Manila and sisal 3-, 4- and 8-strand ropes Cordages en fibres Abaca (manille) et sisal Cordages 3, 4 et 8 torons ISO 1181:2004(E) PDF disclaimer This PDF file may contain embedded typefac
2、es. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringi
3、ng Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimiz
4、ed for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2004 All rights reserved. Unless otherwise specified, no pa
5、rt of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale
6、56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2004 All rights reserved -,-,- ISO 1181:2004(E) ISO 2004 All rights reserved iii Contents Page Forewordiv 1 Scope1 2 Normative references .1 3 Terms and definitio
7、ns.1 4 Designation1 5 General requirements.2 6 Lubrication and finish.3 7 Physical properties.3 8 Marking.6 -,-,- ISO 1181:2004(E) iv ISO 2004 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodi
8、es). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and
9、non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, P
10、art 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casti
11、ng a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 1181 was prepared by the European Committee for Standardization (CEN) Technical Commit
12、tee CEN/TC 248, Textiles and textile products, in collaboration with Technical Committee ISO/TC 38, Textiles, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). This third edition cancels and replaces the second edition (ISO 1181:1990), which has been t
13、echnically revised. INTERNATIONAL STANDARD ISO 1181:2004(E) ISO 2004 All rights reserved 1 Fibre ropes Manila and sisal 3-, 4- and 8-strand ropes 1 Scope This International Standard specifies requirements for 3-strand hawser-laid and 4-strand shroud-laid ropes and 8-strand braided ropes for general
14、service made of manila and sisal and gives rules for their designation. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced
15、 document (including any amendments) applies. ISO 1968, Fibre ropes and cordage Terms and definitions ISO 2307, Ropes Determination of certain physical and mechanical properties ISO 95541), Fibre ropes General specification 3 Terms and definitions For the purposes of this document, the terms and def
16、initions given in ISO 1968 apply. 4 Designation Fibre ropes shall be designated by the following: the words “fibre rope”; the number of this International Standard; the construction type of rope (see Clause 5); the reference number of the rope; the material from which the rope is made. EXAMPLE Desig
17、nation of a 3-strand hawser-laid rope, reference number 52 (type A) corresponding to a linear density of 1 870 ktex made of manila (MA): Fibre rope ISO 1181 - A - 52 - MA. 1) To be published. -,-,- ISO 1181:2004(E) 2 ISO 2004 All rights reserved 5 General requirements 5.1 Manila ropes and sisal rope
18、s shall be made in one of the following constructions: type A: 3-strand hawser-laid rope (see Figure 1); type B: 4-strand shroud-laid rope (see Figure 2); type L: 8-strand braided rope (see Figure 3). 5.2 Construction, manufacture, lay, labelling, packaging, invoicing and delivery lengths shall be i
19、n accordance with ISO 9554. Figure 1 Shape of a 3-strand hawser-laid rope (type A) Figure 2 Shape of a 4-strand shroud-laid rope (type B) Figure 3 Shape of an 8-strand braided rope (type L) -,-,- ISO 1181:2004(E) ISO 2004 All rights reserved 3 6 Lubrication and finish 6.1 Lubrication For the purpose
20、 of dressing the fibre, and for the preservation of the rope, a lubricant may be added to manila and sisal ropes. The quantity of dressing applied to the fibre shall, when determined as described in ISO 2307, Clause 12, be not more than 15 % as calculated on the dry mass of the finished rope. 6.2 Fi
21、nish No colouring matter, except that of the rot-proofing agent, water-repellent medium or other materials used to protect against mould growth, shall be used. When a water repellency treatment is required, the medium shall not be soluble in water and shall be of such a nature that it lubricates the
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 1181 2004
链接地址:https://www.31doc.com/p-3774386.html