ISO-13226-2005.pdf
《ISO-13226-2005.pdf》由会员分享,可在线阅读,更多相关《ISO-13226-2005.pdf(34页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 13226:2005(E) ISO 2005 INTERNATIONAL STANDARD ISO 13226 Second edition 2005-11-01 Rubber Standard reference elastomers (SREs) for characterizing the effect of liquids on vulcanized rubbers Caoutchouc lastomres de rfrence normaliss (SRE) pour la caractrisation de leffet des liqu
2、ides sur les caoutchoucs vulcaniss Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/12/2007 20:51:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 13226:20
3、05(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this
4、file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info
5、 relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
6、ISO 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in t
7、he country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2005 All rights reserved Copyright International Organization for Standardization Provided by IHS u
8、nder license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/12/2007 20:51:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 13226:2005(E) ISO 2005 All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope . 1 2 Normative refer
9、ences. 1 3 Composition 2 4 Preparation 2 5 Description 2 6 Test sheet properties 2 7 Designation . 2 8 Storage. 2 Annex A (normative) Acrylic rubbers: SRE-ACM/1 and SRE-ACM/1X 3 Annex B (normative) Acrylonitrile-butadiene rubbers: SRE-NBR 28/P and SRE-NBR 28/PX 5 Annex C (normative) Acrylonitrile-bu
10、tadiene rubbers: SRE-NBR 28/S, SRE-NBR 28/SX, SRE-NBR 34/S and SRE-NBR 34/SX . 8 Annex D (normative) Acrylonitrile-butadiene rubbers: SRE-NBR/M. 12 Annex E (normative) Acrylonitrile-butadiene rubbers: SRE-NBR/L . 13 Annex F (normative) Chlorobutyl rubbers: SRE-CIIR/1 14 Annex G (normative) Chloropre
11、ne rubbers: SRE-CR/1 15 Annex H (normative) Ethylene-propylene rubbers: SRE-EPM/1 . 16 Annex I (normative) Fluoropolymer rubbers: SRE-FKM/1. 17 Annex J (normative) Fluoropolymer rubbers: SRE-FKM/2X 18 Annex K (normative) Hydrogenated acrylonitrile-butadiene rubbers: SRE-HNBR/1 and SRE-HNBR/1X 21 Ann
12、ex L (normative) Natural rubbers: SRE-NR/1 . 24 Annex M (normative) Silicone rubbers: SRE-MQ/1. 25 Annex N (normative) Silicone rubbers: SRE-VMQ1 and SRE-VMQ/1X. 26 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/997
13、2545001 Not for Resale, 04/12/2007 20:51:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 13226:2005(E) iv ISO 2005 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member
14、 bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental
15、 and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directiv
16、es, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies
17、casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 13226 was prepared by Technical Committee ISO/TC 45, Rubber and rubber products,
18、Subcommittee SC 2, Testing and analysis. This second edition cancels and replaces the first edition (ISO 13226:1999), in which the normative references have been updated. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards
19、 1/9972545001 Not for Resale, 04/12/2007 20:51:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 13226:2005(E) ISO 2005 All rights reserved v Introduction The materials covered by this International Standard are specified in Annexes A to N. The following standard elast
20、omers are included: a) Acrylic rubbers: SRE-ACM/1 and SRE-ACM/1X b) Acrylonitrile-butadiene rubbers: SRE-NBR 28/P and SRE-NBR 28/PX SRE-NBR 28/S, SRE-NBR 28/SX, SRE-NBR 34/S and SRE-NBR 34/SX SRE-NBR/M SRE-NBR/L c) Chlorobutyl rubbers: SRE-CIIR/1 d) Chloroprene rubbers: SRE-CR/1 e) Ethylene-propylen
21、e rubbers: SRE-EPM/1 f) Fluoropolymer rubbers: SRE-FKM/1 SRE-FKM/2X g) Hydrogenated acrylonitrile-butadiene rubbers: SRE-HNBR/1 and SRE-HNBR/1X h) Natural rubbers: SRE-NR/1 i) Silicone rubbers: SRE-MQ/1 SRE-VMQ/1 and SRE-VMQ/1X Copyright International Organization for Standardization Provided by IHS
22、 under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/12/2007 20:51:42 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical
23、 Standards 1/9972545001 Not for Resale, 04/12/2007 20:51:42 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 13226:2005(E) ISO 2005 All rights reserved 1 Rubber Standard reference elastomers (SREs) for characterizing the effect of liquids on vulcan
24、ized rubbers WARNING Persons using this International Standard should be familiar with normal laboratory practice. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health pr
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 13226 2005
链接地址:https://www.31doc.com/p-3774431.html