ISO-13731-2001-EF.pdf
《ISO-13731-2001-EF.pdf》由会员分享,可在线阅读,更多相关《ISO-13731-2001-EF.pdf(44页珍藏版)》请在三一文库上搜索。
1、 Reference number Numro de rfrence ISO 13731:2001(E/F) ISO 2001 INTERNATIONAL STANDARD NORME INTERNATIONALE ISO 13731 First edition Premire dition 2001-12-15 Ergonomics of the thermal environment Vocabulary and symbols Ergonomie des ambiances thermiques Vocabulaire et symboles ISO 13731:2001(E/F) PD
2、F disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, pa
3、rties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relativ
4、e to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. PDF Exon
5、ration de responsabilit Le prsent fichier PDF peut contenir des polices de caractres intgres. Conformment aux conditions de licence dAdobe, ce fichier peut tre imprim ou visualis, mais ne doit pas tre modifi moins que lordinateur employ cet effet ne bnficie dune licence autorisant lutilisation de ce
6、s polices et que celles-ci y soient installes. Lors du tlchargement de ce fichier, les parties concernes acceptent de fait la responsabilit de ne pas enfreindre les conditions de licence dAdobe. Le Secrtariat central de lISO dcline toute responsabilit en la matire. Adobe est une marque dpose dAdobe
7、Systems Incorporated. Les dtails relatifs aux produits logiciels utiliss pour la cration du prsent fichier PDF sont disponibles dans la rubrique General Info du fichier; les paramtres de cration PDF ont t optimiss pour limpression. Toutes les mesures ont t prises pour garantir lexploitation de ce fi
8、chier par les comits membres de lISO. Dans le cas peu probable o surviendrait un problme dutilisation, veuillez en informer le Secrtariat central ladresse donne ci-dessous. ISO 2001 The reproduction of the terms and definitions contained in this International Standard is permitted in teaching manual
9、s, instruction booklets, technical publications and journals for strictly educational or implementation purposes. The conditions for such reproduction are: that no modifications are made to the terms and definitions; that such reproduction is not permitted for dictionaries or similar publications of
10、fered for sale; and that this International Standard is referenced as the source document. With the sole exceptions noted above, no other part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permis
11、sion in writing from either ISO at the address below or ISOs member body in the country of the requester. La reproduction des termes et des dfinitions contenus dans la prsente Norme internationale est autorise dans les manuels denseignement, les modes demploi, les publications et revues techniques d
12、estins exclusivement lenseignement ou la mise en application. Les conditions dune telle reproduction sont les suivantes: aucune modification nest apporte aux termes et dfinitions; la reproduction nest pas autorise dans des dictionnaires ou publications similaires destins la vente; la prsente Norme i
13、nternationale est cite comme document source. la seule exception mentionne ci-dessus, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lISO
14、ladresse ci-aprs ou du comit membre de lISO dans le pays du demandeur. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.ch Web www.iso.ch Printed in Switzerland/Imprim en Suisse ii ISO 2001 All rights reserved/Tous droits rservs
15、ISO 13731:2001(E/F) ISO 2001 All rights reserved/Tous droits rservs iii Contents Page Forewordv Introduction.vii 1 Scope1 2 Terms and definitions .1 3 Symbols, terms and units.16 Bibliography30 Alphabetical index31 ISO 13731:2001(E/F) iv ISO 2001 All rights reserved/Tous droits rservs Sommaire Page
16、Avant-proposvi Introductionviii 1 Domaine dapplication.1 2 Termes et dfinitions.1 3 Symboles, termes et units 16 Bibliographie.30 Index alphabtique .33 ISO 13731:2001(E/F) ISO 2001 All rights reserved/Tous droits rservs v Foreword ISO (the International Organization for Standardization) is a worldwi
17、de federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on tha
18、t committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in a
19、ccordance with the rules given in the ISO/IEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard re
20、quires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 13731 was pre
21、pared by Technical Committee ISO/TC 159, Ergonomics, Subcommittee SC 5, Ergonomics of the physical environment. ISO 13731:2001(E/F) vi ISO 2001 All rights reserved/Tous droits rservs Avant-propos LISO (Organisation internationale de normalisation) est une fdration mondiale dorganismes nationaux de n
22、ormalisation (comits membres de lISO). Llaboration des Normes internationales est en gnral confie aux comits techniques de lISO. Chaque comit membre intress par une tude a le droit de faire partie du comit technique cr cet effet. Les organisations internationales, gouvernementales et non gouvernemen
23、tales, en liaison avec lISO participent galement aux travaux. LISO collabore troitement avec la Commission lectrotechnique internationale (CEI) en ce qui concerne la normalisation lectrotechnique. Les Normes internationales sont rdiges conformment aux rgles donnes dans les Directives ISO/CEI, Partie
24、 3. La tche principale des comits techniques est dlaborer les Normes internationales. Les projets de Normes internationales adopts par les comits techniques sont soumis aux comits membres pour vote. Leur publication comme Normes internationales requiert lapprobation de 75 % au moins des comits membr
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 13731 2001 EF
链接地址:https://www.31doc.com/p-3774609.html