ISO-16293-1-2008.pdf
《ISO-16293-1-2008.pdf》由会员分享,可在线阅读,更多相关《ISO-16293-1-2008.pdf(10页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 16293-1:2008(E) ISO 2008 INTERNATIONAL STANDARD ISO 16293-1 First edition 2008-07-01 Glass in building Basic soda lime silicate glass products Part 1: Definitions and general physical and mechanical properties Verre dans la construction Produits de base partir de verre de silic
2、ate sodo-calcique Partie 1: Dfinitions et proprits physiques et mcaniques gnrales Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 07/24/2008 23:38:08 MDTNo reproduction or networking permitted without licen
3、se from IHS -,-,- ISO 16293-1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing t
4、he editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file
5、can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretar
6、iat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing
7、from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2008 All rights reserved Copyright Int
8、ernational Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 07/24/2008 23:38:08 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 16293-1:2008(E) ISO 2008 All rights reserved iii Foreword ISO (the Intern
9、ational Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has b
10、een established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical sta
11、ndardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies f
12、or voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or a
13、ll such patent rights. ISO 16293-1 was prepared by Technical Committee ISO/TC 160, Glass in building, Subcommittee SC 1, Product considerations. ISO 16293 consists of the following parts, under the general title Glass in building Basic soda lime silicate glass products: Part 1: Definitions and gener
14、al physical and mechanical properties A part 2 dealing with float glass is under preparation. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 07/24/2008 23:38:08 MDTNo reproduction or networking permitted w
15、ithout license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 07/24/2008 23:38:08 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 16293-1
16、:2008(E) ISO 2008 All rights reserved 1 Glass in building Basic soda lime silicate glass products Part 1: Definitions and general physical and mechanical properties 1 Scope This part of ISO 16293 defines and classifies basic soda-lime silicate glass products, indicates their chemical composition, th
17、eir main physical and mechanical characteristics and defines their general quality criteria. Specific dimensions and dimensional tolerances, description of faults, quality limits and designation for the product types are not included in this part of ISO 16293. NOTE It is intended to include the spec
18、ific dimensions and dimensional tolerances, description of faults, quality limits and designation for the product types in the future ISO 16293-2, which is specific to float glass. 2 Normative references The following referenced documents are indispensable for the application of this document. For d
19、ated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 9050, Glass in building Determination of light transmittance, solar direct transmittance, total solar energy transmittance, ultraviolet trans
20、mittance and related glazing factors 3 Terms and definitions For the purposes of this document, the following terms and definitions apply. 3.1 float glass flat, transparent, clear or tinted soda-lime silicate glass having parallel and polished faces obtained by continuous casting and flotation on a
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 16293 2008
链接地址:https://www.31doc.com/p-3775908.html