ISO-17080-2005.pdf
《ISO-17080-2005.pdf》由会员分享,可在线阅读,更多相关《ISO-17080-2005.pdf(16页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 17080:2005(E) ISO 2005 INTERNATIONAL STANDARD ISO 17080 First edition 2005-10-15 Manually portable agricultural and forestry machines and powered lawn and garden equipment Design principles for single-panel product safety labels Tracteurs et matriels agricoles et forestiers por
2、tatifs et matriels moteur pour jardins et pelouses Principes de conception des tiquettes de scurit de produit encadr unique Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:03:
3、35 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 17080:2005(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded a
4、re licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Detai
5、ls of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem re
6、lating to it is found, please inform the Central Secretariat at the address given below. ISO 2005 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, wi
7、thout permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2005 All r
8、ights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:03:35 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 17080:2005(E) ISO 2005 All r
9、ights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a su
10、bject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (
11、IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical commi
12、ttees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not b
13、e held responsible for identifying any or all such patent rights. ISO 17080 was prepared by Technical Committee ISO/TC 23, Tractors and machinery for agriculture and forestry, Subcommittee SC 14, Operator controls, operator symbols and other displays, operator manuals. Copyright International Organi
14、zation for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:03:35 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 17080:2005(E) iv ISO 2005 All rights reserved Introduction There is need
15、for a standardized system for the communication of specific safety information on products, and ISO 17080 helps meet that need by providing formats for single-panel product safety labels that can be used to fulfil the requirements of both the product and its user. The formats for single-panel produc
16、t safety labels presented in this International Standard incorporate the use of geometric shapes, colours and hazard pictorials (graphical symbols) to communicate safety information, efficiently, across language barriers. Education is an essential part of any system of safety information. Because th
17、e amount of information necessary to enable a product to be operated or serviced safely could well be more than is able to be conveyed in a product safety label, collateral material (e.g. product literature, installation manual, operators manual, service manual, etc.) can be used to supplement produ
18、ct safety labels and provide the user with additional safety information. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 08:03:35 MDTNo reproduction or networking permitted with
19、out license from IHS -,-,- INTERNATIONAL STANDARD ISO 17080:2005(E) ISO 2005 All rights reserved 1 Manually portable agricultural and forestry machines and powered lawn and garden equipment Design principles for single-panel product safety labels 1 Scope This International Standard establishes princ
20、iples and gives requirements for the design of single-panel product safety labels intended to be permanently affixed to manually portable agricultural and forestry machines and powered lawn and garden equipment. The main usage of these labels is on machines and equipment where the available space fo
21、r locating product safety information is very limited, and where multi- panel labels are not necessary for conveying the essential safety messages. 2 Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 hazard source of potential injury to a person
22、2.2 panel area of a product safety label that has a distinctive background colour different from adjacent areas of the label, or which is clearly delineated by a border 2.3 multi-panel product safety label product safety label that uses more than one panel to communicate the safety message NOTE See
23、ISO 11684. 2.4 product safety label label on a product that informs the observer of one or more hazards and/or describes the safety precautions or actions required to avoid the hazard(s) NOTE A product safety label communicates a hazardous situation, a precaution to avoid a hazard, and/or a result o
24、f not avoiding a hazard. 2.5 safety colour colour with special properties to which a safety meaning is attributed 2.6 single-panel product safety label product safety label that uses one panel to communicate the safety message Copyright International Organization for Standardization Provided by IHS
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 17080 2005
链接地址:https://www.31doc.com/p-3776151.html