ISO-16000-11-2006.pdf
《ISO-16000-11-2006.pdf》由会员分享,可在线阅读,更多相关《ISO-16000-11-2006.pdf(20页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 16000-11:2006(E) ISO 2006 INTERNATIONAL STANDARD ISO 16000-11 First edition 2006-02-01 Indoor air Part 11: Determination of the emission of volatile organic compounds from building products and furnishing Sampling, storage of samples and preparation of test specimens Air intrie
2、ur Partie 11: Dosage de lmission de composs organiques volatils de produits de construction et dobjets dquipement chantillonnage, conservation des chantillons et prparation dchantillons pour essai ISO 16000-11:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Ad
3、obes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing polic
4、y. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every ca
5、re has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2006 All rights reserved. Unless otherwise specified, no part of this publication ma
6、y be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel.
7、 + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2006 All rights reserved ISO 16000-11:2006(E) ISO 2006 All rights reserved iii Contents Page Foreword iv Introduction. vi 1 Scope 1 2 Normative references1 3 Terms and definitions .2 4 Sa
8、mpling the product and transport and storage of sample2 5 Preparation of test specimens .3 Annex A (normative) Solid products Procedure for sampling and test specimen preparation.4 Annex B (normative) Liquid products Procedure for sampling and test specimen preparation.7 Annex C (informative) Combin
9、ed products10 Bibliography12 ISO 16000-11:2006(E) iv ISO 2006 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out throug
10、h ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborat
11、es closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standard
12、s. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of thi
13、s document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 16000-11 was prepared by the European Committee for Standardization (CEN) Technical Committee CEN/TC 264, Air quality, in collaboration with Technical Committee ISO/TC
14、 146, Air quality, Subcommittee SC 6, Indoor air, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). ISO 16000 consists of the following parts, under the general title Indoor air: Part 1: General aspects of sampling strategy Part 2: Sampling strategy fo
15、r formaldehyde Part 3: Determination of formaldehyde and other carbonyl compounds Active sampling method Part 4: Determination of formaldehyde Diffusive sampling method Part 5: Measurement strategy for volatile organic compounds (VOCs) Part 6: Determination of volatile organic compounds in indoor an
16、d test chamber air by active sampling on Tenax TA sorbent, thermal desorption and gas chromatography using MS/FID Part 7: Sampling strategy for determination of airborne asbestos fibre concentrations Part 8: Determination of local mean ages of air in buildings for characterizing ventilation conditio
17、ns Part 9: Determination of the emission of volatile organic compounds from building products and furnishing Emission test chamber method Part 10: Determination of the emission of volatile organic compounds from building products and furnishing Emission test cell method Part 11: Determination of the
18、 emission of volatile organic compounds from building products and furnishing Sampling, storage of samples and preparation of test specimens The following parts are under preparation: Part 12: Sampling strategy for polycyclic aromatic hydrocarbons (PAHs), polychlorinated dibenzo-p- dioxins (PCDDs),
19、polychlorinated dibenzo-furans (PCDFs) and polychlorinated biphenyls (PCBs) ISO 16000-11:2006(E) ISO 2006 All rights reserved v Part 13: Determination of total (gas and particle-phase) polychlorinated dioxin-like biphenyls and polychlorinated dibenzo-p-dioxins/dibenzofurans Collection on sorbent-bac
20、ked filters with high- resolution gas chromatographic/mass spectrometric analysis Part 14: Sampling strategy for nitrogen dioxide (NO2) Part 15: Measurement of nitrogen dioxide (NO2) Part 16: Detection and enumeration of moulds Sampling of moulds by filtration Part 17: Detection and enumeration of m
21、oulds Culture-based method ISO 16000-11:2006(E) vi ISO 2006 All rights reserved Introduction The determination of volatile organic compounds (VOCs) emitted from building products using emission test chambers in conjunction with the standardised sampling, storage of samples and preparation of test sp
22、ecimens has objectives such as: to provide manufacturers, builders, and end users with emission data useful for the evaluation of the impact of building products on the indoor air quality; to promote the development of improved products. The method can in principle be used for most building products
23、 used indoors. INTERNATIONAL STANDARD ISO 16000-11:2006(E) ISO 2006 All rights reserved 1 Indoor air Part 11: Determination of the emission of volatile organic compounds from building products and furnishing Sampling, storage of samples and preparation of test specimens 1 Scope Studies of the emissi
24、on of volatile organic compounds from unused building products or furnishing in test chambers or cells require proper handling of the product prior to testing, and during the testing period. This part of ISO 16000 defines three types of building products or furnishing: solid, liquid and combined. Fo
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 16000 11 2006
链接地址:https://www.31doc.com/p-3776173.html