ISO-1929-1993.pdf
《ISO-1929-1993.pdf》由会员分享,可在线阅读,更多相关《ISO-1929-1993.pdf(6页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD IS0 1929 Second edition 1993-07-l 5 Abrasive belts - Dimensions, tolerances and designation Bandes abrasives - Dimensions, tokrances et dksignation Reference number IS0 1929:1993(E) Copyright International Organization for Standardization Provided by IHS under license with ISO
2、 Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/27/2007 21:07:29 MDTNo reproduction or networking permitted without license from IHS -,-,- IS0 1929:1993(E) Foreword IS0 (the International Organization for Standardization) is a worldwide federation of national standards bodies (IS0
3、 member bodies). The work of preparing International Standards is normally carried out through IS0 technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, gover
4、nmental and non-governmental, in liaison with ISO, also take part in the work. IS0 collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the
5、 member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard IS0 1929 was prepared by Technical Committee lSO/TC 29, Small too/s, Sub-Committee SC 5, Grinding wheels and abras- ives. This second edi
6、tion cancels and replaces the first edition (IS0 1929:1974), of which the table in subclause 4.2 (corresponding to table 2 in the present edition) has been technically revised. Annex A of this International Standard is for information only. 0 IS0 1993 All rights reserved. No part of this publication
7、 may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without per- mission in writing from the publisher. International Organization for Standardization Case Postale 56 l CH-1211 Geneve 20 l Switzerland Printed in Switzerland ii C
8、opyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/27/2007 21:07:29 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD IS0 1929:1993(E) Abrasive
9、 belts - Dimensions, tolerances and designation 1 Scope This International Standard specifies the dimensions and tolerances, in millimetres, of abrasive belts in general, and their designation. 2 Nominal dimensions and tolerances 2.1 Widths, 1 See table 1. 2.2 Lengths, L See table 2. 3 Cylindricity
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 1929 1993
链接地址:https://www.31doc.com/p-3776258.html