ISO-1641-2-1978.pdf
《ISO-1641-2-1978.pdf》由会员分享,可在线阅读,更多相关《ISO-1641-2-1978.pdf(5页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD 1641 I II INTERNATIONAL ORGANIZATION FOR STANDARDIZATION .MEI/.IYHAPOILHAR OPI-AHW3AUWR n0 CTAHjlAIlM3AUWi.ORGANISATION INTERNATIONALE DE NORMALISATION End mills and slot drills - Part II : Milling cutters with Morse taper shanks Fraises cylindriques 2 tailles et fraises ii ra
2、inurer - Par-tie II : Fraises B queue c those with 7/24 taper shanks, in part I I I. 2 REFERENCES IS0 296, Self-holding tapers for tool shanks. IS0 523, Milling cutters - Recommended range of outside diameters. IS0 3655, Milling cutters - Nomenclature. IS0 5413, Machine tools - Positive drive of Mor
3、se tapers. 3 DIMENSIONS Flat-ended end mills and ball-nosed parallel-end mills Two series : standard and long according to the cutting length 1. Slot drills Two series : short series and standard series according to the cutting length 1. Copyright International Organization for Standardization Provi
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 1641 1978
链接地址:https://www.31doc.com/p-3776348.html