ISO-20863-2004.pdf
《ISO-20863-2004.pdf》由会员分享,可在线阅读,更多相关《ISO-20863-2004.pdf(12页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 20863:2004(E) ISO 2004 INTERNATIONAL STANDARD ISO 20863 First edition 2004-12-01 Footwear Test methods for stiffeners and toepuffs Bondability Chaussures Mthodes dessai pour contreforts et renforts Aptitude au collage Copyright International Organization for Standardization Pro
2、vided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:10:24 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20863:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, t
3、his file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secre
4、tariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ens
5、ure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utili
6、zed in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +
7、 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2004 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:10:24 MDTNo reproduction or ne
8、tworking permitted without license from IHS -,-,- ISO 20863:2004(E) ISO 2004 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally
9、 carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the w
10、ork. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare Int
11、ernational Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of
12、the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 20863 was prepared by the European Committee for Standardization (CEN) in collaboration with Technical Committee ISO/TC 216, Footwear, in accordance
13、 with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). Throughout the text of this document, read “.this European Standard.” to mean “.this International Standard.”. Annex ZA provides a list of corresponding International and European Standards for which equivalents are
14、 not given in the text. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:10:24 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20863:2004(E) iv ISO 2004 All rights
15、 reserved Contents Page Forewordv 1 Scope 1 2 Normative references 1 3 Terms and definitions .1 4 Apparatus and materials.1 5 Sampling and conditioning.2 5.1 Method 1: Heat activated materials2 5.2 Method 2: Solvent activated materials 2 6 Procedure .2 7 Expression of results 3 7.1 Dry bondability.3
16、 7.2 Wet bondability 3 8 Test report 4 Annex ZA (normative) Normative references to International publications with their corresponding European publications5 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale,
17、 04/23/2007 03:10:24 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20863:2004(E) ISO 2004 All rights reserved v Foreword This document (EN ISO 20863:2004) has been prepared by Technical Committee CEN/TC 309 “Footwear“, the secretariat of which is held by AENOR, in col
18、laboration with Technical Committee ISO/TC 216 “Footwear“. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by June 2005, and conflicting national standards shall be withdrawn at the latest by June 20
19、05. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia
20、, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:10:24
21、MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:10:24 MDTNo reproduction or networking permitted without license from
22、IHS -,-,- ISO 20863:2004(E) ISO 2004 All rights reserved 1 1 Scope This document specifies a method for the determination of the bondability of heat activated and solvent activated stiffeners and toepuffs to upper and lining materials. 2 Normative references The following referenced documents are in
23、dispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 12222, Footwear Standard atmospheres for conditioning and testing of footwear and compo
24、nents for footwear. EN ISO 3696, Water for analytical laboratory use Specification and test methods (ISO 3696:1987). EN ISO 4048, Leather Determination of matter soluble in dichloromethane (ISO 4048:1977). EN ISO 7500-1, Metallic materials Verification of static uniaxial testing machines Part 1: Ten
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 20863 2004
链接地址:https://www.31doc.com/p-3776352.html