ISO-1750-AMD-5-2008.pdf
《ISO-1750-AMD-5-2008.pdf》由会员分享,可在线阅读,更多相关《ISO-1750-AMD-5-2008.pdf(108页珍藏版)》请在三一文库上搜索。
1、 Reference number Numro de rfrence ISO 1750:1981/Amd.5:2008(E/F) ISO 2008 INTERNATIONAL STANDARD NORME INTERNATIONALE ISO 1750 First edition Premire dition 1981-12-15 AMENDMENT 5 AMENDEMENT 5 2008-11-01 Pesticides and other agrochemicals Common names AMENDMENT 5 Produits phytosanitaires et assimils
2、Noms communs AMENDEMENT 5 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/29/2009 19:02:30 MSTNo reproduction or networking permitted without license from IHS -,-,- ISO 1750:1981/Amd.5:2008(E/F) PDF disc
3、laimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties
4、accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to t
5、he file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. PDF Exonration
6、 de responsabilit Le prsent fichier PDF peut contenir des polices de caractres intgres. Conformment aux conditions de licence dAdobe, ce fichier peut tre imprim ou visualis, mais ne doit pas tre modifi moins que lordinateur employ cet effet ne bnficie dune licence autorisant lutilisation de ces poli
7、ces et que celles-ci y soient installes. Lors du tlchargement de ce fichier, les parties concernes acceptent de fait la responsabilit de ne pas enfreindre les conditions de licence dAdobe. Le Secrtariat central de lISO dcline toute responsabilit en la matire. Adobe est une marque dpose dAdobe System
8、s Incorporated. Les dtails relatifs aux produits logiciels utiliss pour la cration du prsent fichier PDF sont disponibles dans la rubrique General Info du fichier; les paramtres de cration PDF ont t optimiss pour limpression. Toutes les mesures ont t prises pour garantir lexploitation de ce fichier
9、par les comits membres de lISO. Dans le cas peu probable o surviendrait un problme dutilisation, veuillez en informer le Secrtariat central ladresse donne ci-dessous. COPYRIGHT PROTECTED DOCUMENT DOCUMENT PROTG PAR COPYRIGHT ISO 2008 All rights reserved. Unless otherwise specified, no part of this p
10、ublication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. / Droits de reproduction rservs. Sauf prescrip
11、tion diffrente, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcanique, y compris la photocopie et les microfilms, sans laccord crit de lISO ladresse ci-aprs ou du comit membre de lISO dans le pays du demandeur.
12、 ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland/Publi en Suisse ii ISO 2008 All rights reserved/Tous droits rservs Copyright International Organization for Standardization Provided b
13、y IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/29/2009 19:02:30 MSTNo reproduction or networking permitted without license from IHS -,-,- ISO 1750:1981/Amd.5:2008(E/F) ISO 2008 All rights reserved/Tous droits rservs iii Foreword ISO (the International Organization for
14、Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the r
15、ight to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Internation
16、al Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as
17、 an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Am
18、endment 5 to ISO 1750:1981 was prepared by Technical Committee ISO/TC 81, Common names for pesticides and other agrochemicals. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 01/29/2009 19:02:30 MSTNo repro
19、duction or networking permitted without license from IHS -,-,- ISO 1750:1981/Amd.5:2008(E/F) iv ISO 2008 All rights reserved/Tous droits rservs Avant-propos LISO (Organisation internationale de normalisation) est une fdration mondiale dorganismes nationaux de normalisation (comits membres de lISO).
20、Llaboration des Normes internationales est en gnral confie aux comits techniques de lISO. Chaque comit membre intress par une tude a le droit de faire partie du comit technique cr cet effet. Les organisations internationales, gouvernementales et non gouvernementales, en liaison avec lISO participent
21、 galement aux travaux. LISO collabore troitement avec la Commission lectrotechnique internationale (CEI) en ce qui concerne la normalisation lectrotechnique. Les Normes internationales sont rdiges conformment aux rgles donnes dans les Directives ISO/CEI, Partie 2. La tche principale des comits techn
22、iques est dlaborer les Normes internationales. Les projets de Normes internationales adopts par les comits techniques sont soumis aux comits membres pour vote. Leur publication comme Normes internationales requiert lapprobation de 75 % au moins des comits membres votants. Lattention est appele sur l
23、e fait que certains des lments du prsent document peuvent faire lobjet de droits de proprit intellectuelle ou de droits analogues. LISO ne saurait tre tenue pour responsable de ne pas avoir identifi de tels droits de proprit et averti de leur existence. LAmendement 5 lISO 1750:1981 a t labor par le
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 1750 AMD 2008
链接地址:https://www.31doc.com/p-3776404.html