ISO-20345-2004.pdf
《ISO-20345-2004.pdf》由会员分享,可在线阅读,更多相关《ISO-20345-2004.pdf(36页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 20345:2004(E) ISO 2004 INTERNATIONAL STANDARD ISO 20345 First edition 2004-08-01 Personal protective equipment Safety footwear quipement de protection individuelle Chaussures de scurit Copyright International Organization for Standardization Provided by IHS under license with I
2、SO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 05/08/2007 07:35:57 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20345:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file m
3、ay be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat acc
4、epts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that t
5、he file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any
6、 form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749
7、 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2004 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 05/08/2007 07:35:57 MDTNo repro
8、duction or networking permitted without license from IHS -,-,- ISO 20345:2004(E) ISO 2004 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standard
9、s is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take
10、part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is t
11、o prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility
12、that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 20345 was prepared by the European Committee for Standardization (CEN) in collaboration with Technical Committee ISO/TC 94, Personal sa
13、fety Protective clothing and equipment, Subcommittee SC 3, Foot protection, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). Throughout the text of this document, read “.this European Standard.” to mean “.this International Standard.”. This first edit
14、ion of ISO 20345 cancels and replaces ISO 8782-2:1998, which has been technically revised. For the purposes of this International Standard the CEN annex regarding fulfilment of European Council Directives has been removed. Copyright International Organization for Standardization Provided by IHS unde
15、r license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 05/08/2007 07:35:57 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20345:2004(E) iv ISO 2004 All rights reserved Contents page Forewordv 1 Scope 1 2 Normative references 1 3 Terms a
16、nd definitions .1 4 Classification6 5 Basic requirements for safety footwear7 5.1 General7 5.2 Design.9 5.3 Whole footwear 10 5.4 Upper.12 5.5 Lining 14 5.6 Tongue14 5.7 Insole and insock.15 5.8 Outsole16 6 Additional requirements for safety footwear17 6.1 General .17 6.2 Whole footwear17 6.3 Upper
17、21 6.4 Outsole .22 7 Marking.23 8 Information to be supplied .24 8.1 General .24 8.2 Electrical properties25 8.3 Insocks .27 Bibliography28 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Res
18、ale, 05/08/2007 07:35:57 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20345:2004(E) ISO 2004 All rights reserved v Foreword This document (EN ISO 20345:2004) has been prepared by Technical Committee CEN/TC 161 “Foot and leg protectors”, the secretariat of which is he
19、ld by BSI, in collaboration with Technical Committee ISO/TC 94 “Personal safety - Protective clothing and equipment”. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by February 2005, and conflicting
20、 national standards shall be withdrawn at the latest by August 2005. This document has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association, and supports essential requirements of EU Directive(s). In conjunction with EN ISO 20344: 2004, this s
21、tandard supersedes EN 345:1992 and EN 345-2:1996. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Gr
22、eece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employe
23、es/1111111001, User=Wing, Bernie Not for Resale, 05/08/2007 07:35:57 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for
24、Resale, 05/08/2007 07:35:57 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 20345:2004(E) ISO 2004 All rights reserved 1 1 Scope This European Standard specifies basic and additional (optional) requirements for safety footwear. 2 Normative references The following refer
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 20345 2004
链接地址:https://www.31doc.com/p-3776630.html