ISO-24751-1-2008.pdf
《ISO-24751-1-2008.pdf》由会员分享,可在线阅读,更多相关《ISO-24751-1-2008.pdf(44页珍藏版)》请在三一文库上搜索。
1、 Reference number Numro de rfrence ISO/IEC 24751-1:2008(E/F) ISO/IEC 2008 INTERNATIONAL STANDARD NORME INTERNATIONALE ISO/IEC 24751-1 First edition Premire dition 2008-10-01 Information technology Individualized adaptability and accessibility in e-learning, education and training Part 1: Framework a
2、nd reference model Technologies de linformation Adaptabilit et accessibilit individualises en e-apprentissage, en ducation et en formation Partie 1: Cadre et modle de rfrence Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001
3、 Not for Resale, 10/25/2008 04:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 24751-1:2008(E/F) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited
4、 unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trad
5、emark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodie
6、s. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. PDF Exonration de responsabilit Le prsent fichier PDF peut contenir des polices de caractres intgres. Conformment aux conditions de licence dAdobe, ce fichier peut tre i
7、mprim ou visualis, mais ne doit pas tre modifi moins que lordinateur employ cet effet ne bnficie dune licence autorisant lutilisation de ces polices et que celles-ci y soient installes. Lors du tlchargement de ce fichier, les parties concernes acceptent de fait la responsabilit de ne pas enfreindre
8、les conditions de licence dAdobe. Le Secrtariat central de lISO dcline toute responsabilit en la matire. Adobe est une marque dpose dAdobe Systems Incorporated. Les dtails relatifs aux produits logiciels utiliss pour la cration du prsent fichier PDF sont disponibles dans la rubrique General Info du
9、fichier; les paramtres de cration PDF ont t optimiss pour limpression. Toutes les mesures ont t prises pour garantir lexploitation de ce fichier par les comits membres de lISO. Dans le cas peu probable o surviendrait un problme dutilisation, veuillez en informer le Secrtariat central ladresse donne
10、ci-dessous. COPYRIGHT PROTECTED DOCUMENT DOCUMENT PROTG PAR COPYRIGHT ISO 2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in
11、 writing from either ISO at the address below or ISOs member body in the country of the requester. / Droits de reproduction rservs. Sauf prescription diffrente, aucune partie de cette publication ne peut tre reproduite ni utilise sous quelque forme que ce soit et par aucun procd, lectronique ou mcan
12、ique, y compris la photocopie et les microfilms, sans laccord crit de lISO ladresse ci-aprs ou du comit membre de lISO dans le pays du demandeur. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in S
13、witzerland/Publi en Suisse ii ISO/IEC 2008 All rights reserved/Tous droits rservs Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:57:51 MDTNo reproduction or networking permitted without licen
14、se from IHS -,-,- ISO/IEC 24751-1:2008(E/F) ISO/IEC 2008 All rights reserved/Tous droits rservs iii Contents Page Foreword. v Introduction vii 1 Scope 1 1.1 Statement of Scope .1 1.2 Exclusions2 1.2.1 The creation of accessible content2 1.2.2 Person: organization and public administration2 1.3 Aspec
15、ts not currently addressed.2 2 Terms and definitions .3 3 Symbols and abbreviations8 4 Basic principles .9 4.1 Two types of parts in this multi-part standard .9 4.2 Extending the standard.12 4.3 Disability and accessibility.12 4.4 The importance of interoperability and consistent implementation13 5
16、Abstract model.14 6 Multilinguality.19 7 Conformance19 Annex A (normative) Consolidated list of terms: in French alphabetical order.20 Annex B (informative) Alternative access terms22 Annex C (informative) Accessibility policies and legislation .31 Annex D (informative) List of contributors.32 Bibli
17、ography33 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 24751-1:2008(E/F) iv ISO/IEC 2008 All rights r
18、eserved/Tous droits rservs Sommaire Page Avant-propos.vi Introduction .viii 1 Domaine dapplication1 1.1 nonc du domaine dapplication.1 1.2 Exclusions .2 1.2.1 La cration de contenu accessible .2 1.2.2 Personne: organisation et administration publique2 1.3 Autres aspects non couverts actuellement2 2
19、Termes et dfinitions3 3 Symboles et abrviations.8 4 Principes de base9 4.1 Deux types de parties dans la norme multiparties9 4.2 Extension de la norme12 4.3 Dficience et accessibilit12 4.4 Importance de linteroprabilit et de lapplication cohrente.13 5 Modle abstrait14 6 Multilinguisme.19 7 Conformit
20、.19 Annexe A (normative) Liste de termes consolide: dans lordre alphabtique franais20 Annexe B (informative) Termes daccs alternatifs 22 Annexe C (informative) Politiques et lgislation en matire daccessibilit 31 Annexe D (informative) Liste des contributeurs32 Bibliographie 33 Copyright Internationa
21、l Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:57:51 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 24751-1:2008(E/F) ISO/IEC 2008 All rights reserved/Tous droits rservs v Forewo
22、rd ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical co
23、mmittees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in th
24、e work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare Internationa
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 24751 2008
链接地址:https://www.31doc.com/p-3776728.html