ISO-22199-2006.pdf
《ISO-22199-2006.pdf》由会员分享,可在线阅读,更多相关《ISO-22199-2006.pdf(16页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 22199:2006(E) ISO 2006 INTERNATIONAL STANDARD ISO 22199 First edition 2006-04-15 Electromagnetic compatibility Product family standard for lifts, escalators and moving walks Emission Compatibilit lectromagntique Norme pour la famille de produits: ascenseurs, escaliers mcaniques
2、 et trottoirs roulants mission Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 07:46:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22199:2006(E
3、) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file
4、, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info rel
5、ative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO
6、2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the c
7、ountry of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2006 All rights reserved Copyright International Organization for Standardization Provided by IHS under
8、 license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 07:46:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22199:2006(E) ISO 2006 All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope 1 2 Normative references1
9、 3 Terms and definitions .1 4 Composition of subsystems.2 5 Test set-up3 6 Applicability of tests3 7 Emission limits.3 8 Documentation for the user of the subsystem or apparatus4 Annex A (informative) Special provision for test site measurement (radiation measurement) 9 kHz to 1 GHz8 Bibliography9 C
10、opyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/20/2007 07:46:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22199:2006(E) iv ISO 2006 All rights reserve
11、d Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a
12、 technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matte
13、rs of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circula
14、ted to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsibl
15、e for identifying any or all such patent rights. ISO 22199 was prepared by Technical Committee ISO/TC 178, Lifts, escalators and moving walks. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale
16、, 04/20/2007 07:46:42 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22199:2006(E) ISO 2006 All rights reserved v Introduction This International Standard is based upon the European Standard EN 12015:1998. This International Standard contains no technical deviations fr
17、om EN 12015:1998. In the meantime, EN 12016:2004, which supersedes EN 12016:1998, has been published with new requirements to control the emissions below 30 MHz of the drive to machine/motor connection and mains electricity supply harmonic emissions and voltage fluctuations. As of the publication da
18、te of this International Standard, an ISO/TC 178 resolution has been opened to address these new requirements in the next revision of ISO 22199. The limits given in this International Standard recognize the fact that the product family covers a total range of lifts, escalators and moving walks used
19、in residential buildings, offices, hospitals, hotels, industrial plants etc. and that lifts, escalators and passenger conveyors are deemed to have their own dedicated power supply and be connected with the consent of the supply authority to a low impedance source. This International Standard is the
20、product family standard for the electromagnetic compatibility of lifts, escalators and moving walks (emission) and takes precedence over all aspects of the generic standard. The ISO/TC 178/WG8 committee, responsible for this International Standard, is aware that the normatively referenced documents
21、CISPR 11 and CISPR 14-1 have been revised since the development of this document. In order to keep this International Standard active, WG8 is preparing, as of the date of publication of this International Standard, a simple amendment (editorial) that allows for a current version of the CISPR documen
22、ts to be referenced without any modification to the technical requirements of this International Standard as published. The amendment will be available in the near future. The related EMC product family standard for immunity is ISO 22200. The requirements of this International Standard have been spe
23、cified so as to ensure a level of electromagnetic emission that causes minimal disturbance to other equipment. The levels, however, do not cover the following cases: a) where the probability of an occurrence likely to produce emissions in excess of those which are normally experienced is extremely l
24、ow, e.g. the emergency stopping of a lift, escalator or passenger conveyor under a fault condition; b) where highly susceptible apparatus is used in the close proximity of the equipment covered by this International Standard, in which case further measures might have to be taken to: reduce the elect
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 22199 2006
链接地址:https://www.31doc.com/p-3776747.html