ISO-4190-5-2006.pdf
《ISO-4190-5-2006.pdf》由会员分享,可在线阅读,更多相关《ISO-4190-5-2006.pdf(26页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 4190-5:2006(E) ISO 2006 INTERNATIONAL STANDARD ISO 4190-5 Third edition 2006-11-01 Lift (Elevator) installation Part 5: Control devices, signals and additional fittings Installation dascenseurs Partie 5: Dispositifs de commande et de signalisation et accessoires complmentaires
2、Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 19:57:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 4190-5:2006(E) PDF disclaimer This PDF file
3、 may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the r
4、esponsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-cre
5、ation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2006 All rights reserved. Unle
6、ss otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO c
7、opyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2006 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NAS
8、A Technical Standards 1/9972545001 Not for Resale, 04/18/2007 19:57:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 4190-5:2006(E) ISO 2006 All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope . 1 2 Normative references. 1 3 Specifications relatin
9、g to controls 2 4 Handrail 8 Annex A (normative) Special systems. 9 Annex B (informative) Particular requirements. 14 Annex C (normative) Representative symbols . 17 Bibliography. 19 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technic
10、al Standards 1/9972545001 Not for Resale, 04/18/2007 19:57:23 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 4190-5:2006(E) iv ISO 2006 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards
11、 bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organiza
12、tions, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in t
13、he ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of
14、 the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 4190-5 was prepared by Technical Committee ISO/TC 178, Lifts,
15、escalators and moving walks. This third edition cancels and replaces the second edition (ISO 4190-5:1987), which has been technically revised. ISO 4190 consists of the following parts, under the general title Lift (Elevator) installation1): Part 1: Class I, II, III and VI lifts Part 2: Class IV lift
16、s Part 3: Service lifts class V Part 5: Control devices, signals and additional fittings Part 6: Passenger lifts to be installed in residential buildings Planning and selection 1) The title, which differs in various respects in the other, previously published, parts, is to form the subject of a Tech
17、nical Corrigendum for each of the parts concerned. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 19:57:23 MDTNo reproduction or networking permitted without license from IHS -,
18、-,- ISO 4190-5:2006(E) ISO 2006 All rights reserved v Introduction This third edition of ISO 4190-5 takes into account the latest studies concerning ergonomics and the needs of various people with disabilities. Many regional disabled peoples associations were associated with this work and were in ag
19、reement with these new concepts. A general consensus had been obtained on the data recorded in this part of ISO 4190. However, due to existing regulations and, in particular, local habits, in some countries it could be difficult to introduce a part of these specifications without certain precautions
20、 being taken (for example, modification of a well-known symbol). Concerning provisions expressed in terms of values (dimensions, sound level, etc.), this part of ISO 4190 often gives two ranges of values: a general range, followed by a recommended range. The range of recommended values is intended a
21、s the target to be reached, as far as is possible, in each country. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 19:57:23 MDTNo reproduction or networking permitted without li
22、cense from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/18/2007 19:57:23 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO
23、 4190-5:2006(E) ISO 2006 All rights reserved 1 Lift (Elevator) installation Part 5: Control devices, signals and additional fittings 1 Scope This part of ISO 4190 specifies the control devices, buttons and indicators to be provided when a lift (US: elevator) is constructed and installed, taking into
24、 account the type of control intended for the lift and also ensuring the ease of access for disabled persons (motor and/or sensory). Annex B gives particular requirements for access. The description of the controls is given only in order to define the buttons and indicators. It does not constitute a
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 4190 2006
链接地址:https://www.31doc.com/p-3777292.html