ISO-3534-2000.pdf
《ISO-3534-2000.pdf》由会员分享,可在线阅读,更多相关《ISO-3534-2000.pdf(20页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD IS0 3543:2000 TECHNICAL CORRIGENDUM 1 Published 2003-12-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION M W A P O f l H A R OPTAHHIHR no CTAHflAPTHIAUHH ORGANISATION INTERNATIONALE DE NORMALISATION Metallic and non-metallic coatings - Measurement of thickness - Beta backscat
2、ter method TECHNICAL CORRIGENDUM 1 Revtements mtalliques et non mtalliques - Mesurage de lpaisseur - Mthode par rtrodiffusion des rayons bta RECTIFICATIF TECHNIQUE I Technical Corrigendum 1 to IS0 3543:2000 was prepared by Technical Committee ISO/TC 107, Metallic and other inorganic coatings, Subcom
3、mittee SC 2, Test methods. Page 6 Subclause 5.1, paragraph 2, line 3 shall read it is often helpful to express the standard deviation as a percentage of the count, that is I O O f i l X , or lOO/fi. Page 14 Figure A. 1 : the isotopes shall be indicated against each curve; in descending order they ar
4、e: Sr-90 RU-I 06 Bi-21 O Ti-204 Pm-147 (2-14 ICs 25.220.20; 25.220.40 Ref. No. IS0 3543:2000/Cor.l:2003(E) O IS0 2003 -All rights reserved Published in Switzerland Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972
5、545001 Not for Resale, 04/19/2007 22:15:42 MDTNo reproduction or networking permitted without license from IHS -,-,- STD-IS0 3543-ENGL 2000 D 4852903 0859308 306 E INTERNATIONAL IS0 STANDARD 3543 Second edition 2000-12-15 Metallic and non-metallic coatings - Measurement of thickness - Beta backscatt
6、er method Revtements mtalliques et non mtalliques - Mesurage de lpaisseur - Methode par rtrodiffusion des rayons befa his material is reproduced from IS0 documents under International Organization for Standardization (EO) Copyright License Nuniber IHYCCi1996. Not for resale. No part of these IS0 doc
7、uments may be reproduced in any form, electronic retrieval System or otherwise, except written consent of IS0 (Case postal 56,121 I Geneva 20, Switzerland. FAX +4 I 22 734 I O 79). IHS or the IS0 Licensors members. Reference number IS0 3543:2000(E) 0 IS0 2000 Copyright International Organization for
8、 Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 22:15:42 MDTNo reproduction or networking permitted without license from IHS -,-,- STDeISO 3543-ENGL 2000 4851903 0859309 242 I ! PDF disclaimer This PDF file may contain
9、 embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibilit
10、y of not infringing Adobes licensing policy. The IS0 Central Secretariat accepts no liabiiity in this Adobe is a trademark of Adobe Systems incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters w
11、ere optimized for printing. Every care has been taken to ensure that the file is suitable for use by IS0 member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. i area. IS0 3543:2000(E) Q IS0 2000 All rights reser
12、ved. Unles otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without pemission in writing from either IS0 at the address below or ISOs member body in the country of the requester
13、. ISO copyright office Case postale 56 CH-121 1 Geneva 20 Tel. + 41 22 749 O 1 11 Fax +41 227490947 E-mail copyright 3iso.ch Web www.iso.ch Printed in Switzerland II Q IS0 2000 -All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licens
14、ee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 22:15:42 MDTNo reproduction or networking permitted without license from IHS -,-,- STD.ISO 35Y3-ENGL 2000 m 4851r903 0859310 Tb4 IS0 3543:2000(E) Contents Page Foreword . iv 1 Scope 1 2 Terms and definitions . 1 3 Principle 4 4 Appa
15、ratus . 6 5 Factors relating to measurement uncertainty 6 6 Calibration of instruments 9 7 Measuring procedure 10 8 Measurement uncertainty . 11 9 Test report 11 Annex A (informative) General information 13 O IS0 2000 -All rights reserved iii Copyright International Organization for Standardization
16、Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 22:15:42 MDTNo reproduction or networking permitted without license from IHS -,-,- STD-IS0 3543-ENGL 2000 m 4851903 065933rL 9TO m IS0 3543:2000(E) Foreword IS0 (the International Organiz
17、ation for Standardization) is a worldwide federation of national standards bodies (IS0 member bodies). The work of preparing International Standards is normally carried out through IS0 technical committees. Each member body interested in a subject for which a technical committee has been established
18、 has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. IS0 collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. I
19、nternational Standards are drafted in accordance with the rules given in the ISOAEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the
20、 member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IS0 shall not be held responsible for identifying any or all such patent rights. International Standard IS0 3543 was prepared by Technica
21、l Committee ISOTTC 107, Metallic and other inorganic coatings, Subcommittee SC 2, Methods of inspection and coordination of test methods. This second edition cancels and replaces the first edition (IS0 3543:1981), which has been technically revised. Annex A of this International Standard is for info
22、rmation only. iv O IS0 2000 -All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 22:15:42 MDTNo reproduction or networking permitted without license from IHS -,-,
23、- STD.ISO 3543-ENGL 20oo 111 4851903 0859312 837 B INTERNATIONAL STANDARD IS0 3543:2O(E) Metallic and non-metallic coatings - Measurement of thickness - Beta backscatter method 1 Scope WARNING Beta backscatter instruments used for the measurement of coating thicknesses use a number of different radi
24、oactive sources. Although the activities of these sources are normally very low, they can present a hazard to health, if incorrectly handled. Therefore, reference should be made to current international and national standards, where these exist. This International Standard specifies a method for the
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 3534 2000
链接地址:https://www.31doc.com/p-3777418.html