ISO-3046-1-2002.pdf
《ISO-3046-1-2002.pdf》由会员分享,可在线阅读,更多相关《ISO-3046-1-2002.pdf(38页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 3046-1:2002(E) ISO 2002 INTERNATIONAL STANDARD ISO 3046-1 Fifth edition 2002-05-01 Reciprocating internal combustion engines Performance Part 1: Declarations of power, fuel and lubricating oil consumptions, and test methods Additional requirements for engines for general use Mo
2、teurs alternatifs combustion interne Performances Partie 1: Dclaration de la puissance et de la consommation de carburant et dhuile de lubrification, et mthodes dessai Exigences supplmentaires pour les moteurs dusage gnral Copyright International Organization for Standardization Provided by IHS unde
3、r license with ISO Licensee=Qatar Petroleum/5943408001 Not for Resale, 04/12/2007 00:48:06 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3046-1:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file m
4、ay be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat acc
5、epts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that t
6、he file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any
7、 form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749
8、 09 47 E-mail copyrightiso.ch Web www.iso.ch Printed in Switzerland ii ISO 2002 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Qatar Petroleum/5943408001 Not for Resale, 04/12/2007 00:48:06 MDTNo reproduction or networking
9、 permitted without license from IHS -,-,- ISO 3046-1:2002(E) ISO 2002 All rights reserved iii Contents Page Forewordv Introductionvi 1 Scope1 2 Normative references1 3 Terms and definitions .2 4 Symbols2 5 Standard reference conditions.2 6 Test method .2 6.1 General2 6.2 Adjusted engines.3 6.3 Non-a
10、djusted engines (pre-set engines).4 6.4 Auxiliaries.5 7 Method of power correction .5 8 Measurement of exhaust emission5 9 Test report5 10 Methods of calculating power adjustment and recalculating specific fuel consumption.5 10.1 General5 10.2 Application .5 10.3 Power adjustment for ambient conditi
11、ons6 10.4 Recalculation of fuel consumption at test or site ambient conditions for adjusted engines7 11 Declarations of power.7 11.1 General7 11.2 Types of power 8 11.3 Types of power application 9 11.4 Types of power statements 9 12 Designation of power10 12.1 Relation of codes to power.10 12.2 Des
12、ignation of power by means of codes.10 12.3 Examples of power designation by the use of codes12 13 Declaration of fuel consumption13 13.1 Fuel consumption13 13.2 Calorific value of fuels 13 13.3 Declaration of specific fuel consumption.13 14 Declarations of lubricating oil consumption 13 15 Informat
13、ion to be supplied by the customer.14 16 Information to be supplied by the engine manufacturer.14 Annex A (normative) Examples of auxiliaries which may be fitted .16 Annex B (informative) Tables for determination of water vapour pressure, ratios and factors.18 Annex C (informative) Example of calcul
14、ating power adjustment and recalculating specific fuel consumption from standard reference conditions or substitute reference conditions to site ambient conditions25 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Qatar Petroleum/5943408001 No
15、t for Resale, 04/12/2007 00:48:06 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3046-1:2002(E) iv ISO 2002 All rights reserved Annex D (informative) Examples of power adjustment from site ambient conditions to test ambient conditions and simulation of site ambient con
16、ditions for adjusted engines28 Bibliography30 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Qatar Petroleum/5943408001 Not for Resale, 04/12/2007 00:48:06 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3046-1:2
17、002(E) ISO 2002 All rights reserved v Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body
18、 interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotec
19、hnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by
20、the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of ISO 3046 may be the subject of pat
21、ent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 3046-1 was prepared by Technical Committee ISO/TC 70, Internal combustion engines. This part of ISO 3046 cancels and replaces ISO 3046-1:1995, ISO 3046-2:1987 and ISO 3046-7:1995, which have been technic
22、ally revised and their technical content combined. ISO 3046 consists of the following parts, under the general title Reciprocating internal combustion engines Performance: Part 1: Declarations of power, fuel and lubricating oil consumptions, and test methods Additional requirements for engines for g
23、eneral use Part 3: Test measurements Part 4: Speed governing Part 5: Torsional vibrations Part 6: Overspeed protection Annex A forms a normative part of this part of ISO 3046. Annexes B, C and D are for information only. Copyright International Organization for Standardization Provided by IHS under
24、license with ISO Licensee=Qatar Petroleum/5943408001 Not for Resale, 04/12/2007 00:48:06 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3046-1:2002(E) vi ISO 2002 All rights reserved Introduction This part of ISO 3046 establishes one “Satellite” standard of the ISO eng
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 3046 2002
链接地址:https://www.31doc.com/p-3777615.html