ISO-4142-2002.pdf
《ISO-4142-2002.pdf》由会员分享,可在线阅读,更多相关《ISO-4142-2002.pdf(10页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD ISO 4142 Second edition 2002-08-15 Reference number ISO 4142:2002(E) ISO 2002 Laboratory glassware Test tubes Verrerie de laboratoire Tubes essais Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards
2、1/9972545001 Not for Resale, 04/24/2007 20:53:54 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 4142:2002(E) ii ISO 2002 All rights reserved PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printe
3、d or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liab
4、ility in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is s
5、uitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by
6、any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mai
7、l copyrightiso.ch Web www.iso.ch Printed in Switzerland Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 20:53:54 MDTNo reproduction or networking permitted without license from I
8、HS -,-,- ISO 4142:2002(E) ISO 2002 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committ
9、ees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the Int
10、ernational Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bo
11、dies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. ISO shall not be held responsible for
12、identifying any or all such patent rights. International Standard ISO 4142 was prepared by Technical Committee ISO/TC 48, Laboratory glassware and related apparatus, Subcommittee SC 2, General laboratory glassware (other than measuring apparatus). This second edition cancels and replaces the first e
13、dition (ISO 4142:1997) by incorporating the following changes: a)culture tubes have been deleted; b)the material has been more precisely specified; c)three types of test tubes have been introduced; d)additional series and nominal sizes have been added. Copyright International Organization for Standa
14、rdization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 20:53:54 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with IS
15、O Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/24/2007 20:53:54 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARDISO 4142:2002(E) ISO 2002 All rights reserved 1 Laboratory glassware Test tubes 1Scope This International Standard spec
16、ifies a range of test tubes, suitable for general laboratory use, fabricated from borosilicate, neutral or soda/lime glass, which are designated Type I, Type II and Type III respectively. 2Normative references The following normative documents contain provisions which, through reference in this text
17、, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most rece
18、nt editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. ISO 695, Glass Resistance to attack by a boiling aqueous solution of
19、 mixed alkali Method of test and classification ISO 719, Glass Hydrolytic resistance of glass grains at 98 C Method of test and classification ISO 1776:1985, Glass Resistance to attack by hydrochloric acid at 100 C Flame emission or flame atomic absorption spectrometric method ISO 3585, Borosilicate
20、 glass 3.3 Properties ISO 4803, Laboratory glassware Borosilicate glass tubing 3Classification and designation The following three types of test tubes are specified. Type I test tubes (borosilicate glass) are suitable for most usual laboratory applications. They will stand most temperatures commonly
21、 used, including boiling of samples. These test tubes are highly chemically resistant. Type II test tubes (neutral glass) are suitable for many less demanding applications, and will withstand moderate warming, e. g. in a water bath, and/or moderate temperature change. They should not be taken from t
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 4142 2002
链接地址:https://www.31doc.com/p-3777621.html