ISO-23001-3-2008.pdf
《ISO-23001-3-2008.pdf》由会员分享,可在线阅读,更多相关《ISO-23001-3-2008.pdf(66页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO/IEC 23001-3:2008(E) ISO/IEC 2008 INTERNATIONAL STANDARD ISO/IEC 23001-3 First edition 2008-10-01 Information technology MPEG systems technologies Part 3: XML IPMP messages Technologies de linformation Technologies des systmes MPEG Partie 3: Messages XML IPMP Copyright Internati
2、onal Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 23001-3:2008(E) PDF disclaimer This PDF file may contain embedded typefaces
3、. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing
4、 Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized
5、 for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2008 All rights reserved. Un
6、less otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO
7、 copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO/IEC 2008 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licens
8、ee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 23001-3:2008(E) ISO/IEC 2008 All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope . 1 2 Normative references. 2 3 Terms and definitions. 2
9、 4 Abbreviated terms 3 5 Namespace conventions 3 6 IPMP Messages Specification . 4 6.1 Introduction. 4 6.2 IPMP Message Containers. 4 6.3 IPMP Messages. 8 6.4 Legacy Messages . 35 Annex A (informative) IPMP Tool Management Protocols. 37 A.1 Introduction. 37 A.2 Instantiation of an IPMP Tool 37 A.3 I
10、nitialisation of an IPMP Tool. 38 A.4 Authentication between IPMP Tools and the IPMP Processor 39 A.5 General IPMP Tool Management. 39 Annex B (informative) The ipmpmsg schema . 41 Bibliography. 58 Copyright International Organization for Standardization Provided by IHS under license with ISO Licens
11、ee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 23001-3:2008(E) iv ISO/IEC 2008 All rights reserved Foreword ISO (the International Organization for Standardization) and IEC (the International Electrotechni
12、cal Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical acti
13、vity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in the work. In the field of information technology, ISO and IEC have established a joint technical commi
14、ttee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare International Standards. Draft International Standards adopted by the joint technical committee are circulated t
15、o national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO and IEC shall not be held respons
16、ible for identifying any or all such patent rights. ISO/IEC 23001-3 was prepared by Joint Technical Committee ISO/IEC JTC 1, Information technology, Subcommittee SC 29, Coding of audio, picture, multimedia and hypermedia information. ISO/IEC 23001 consists of the following parts, under the general t
17、itle Information technology MPEG systems technologies: Part 1: Binary MPEG format for XML Part 2: Fragment request units Part 3: XML IPMP messages Part 4: Codec configuration representation Part 5: Bitstream Syntax Description Language (BSDL) Copyright International Organization for Standardization
18、Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC 23001-3:2008(E) ISO/IEC 2008 All rights reserved v Introduction This part of ISO/IEC 23001 specifies a set of XML
19、 messages exchanged between the components of a device or between devices while performing Intellectual Property Management and Protection (IPMP) operations. The protection mechanisms are based on the IPMP Tool model as defined in ISO/IEC 13818-11, ISO/IEC 14496-13 (MPEG-2/4 IPMP Extensions), and IS
20、O/IEC 21000-4 (MPEG-21 IPMP Components). In order to support the operation of IPMP Tools on a device in an interoperable fashion, this part of ISO/IEC 23001 complements ISO/IEC 21000-4 by defining an XML API for the communication between IPMP Tools and the device on which they operate, or between tw
21、o IPMP Tools. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardi
22、zation Provided by IHS under license with ISO Licensee=Boeing Co/5910770001 Not for Resale, 10/25/2008 04:55:04 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO/IEC 23001-3:2008(E) ISO/IEC 2008 All rights reserved 1 Information technology MPEG syst
23、ems technologies Part 3: XML IPMP messages 1 Scope This part of ISO/IEC 23001 specifies XML IPMP messages (hereinafter IPMP Messages) which are a simple and natural extension of the IPMP Information Descriptors defined in ISO/IEC 21000-4. They allow dispatching of the IPMP information related to a p
24、rotected content element retrieved from the associated digital item to the modules in charge of performing the IPMP operations required to access the protected content element. Furthermore, the XML IPMP Messages provide a standard API allowing the exchange of IPMP information (e.g. decryption keys,
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 23001 2008
链接地址:https://www.31doc.com/p-3778356.html