ISO-6182-6-2006.pdf
《ISO-6182-6-2006.pdf》由会员分享,可在线阅读,更多相关《ISO-6182-6-2006.pdf(20页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 6182-6:2006(E) ISO 2006 INTERNATIONAL STANDARD ISO 6182-6 First edition 2006-03-01 Fire protection Automatic sprinkler systems Part 6 Requirements and test methods for check valves Protection contre lincendie Systmes dextinction automatiques du type sprinkler Partie 6: Exigence
2、s et mthodes dessai des postes de contrle Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 19:45:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 6
3、182-6:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloadi
4、ng this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the Gene
5、ral Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given
6、 below. ISO 2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member b
7、ody in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2006 All rights reserved Copyright International Organization for Standardization Provided
8、by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2007 19:45:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 6182-6:2006(E) ISO 2006 All rights reserved iii Contents Page Foreword iv Introduction v 1 Scope . 1 2 Normat
9、ive references. 1 3 Terms and definitions. 1 4 Requirements 3 5 Production testing and quality control. 8 6 Tests. 8 7 Marking 12 8 Instruction chart 13 Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not
10、for Resale, 04/19/2007 19:45:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 6182-6:2006(E) iv ISO 2006 All rights reserved Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). T
11、he work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-go
12、vernmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
13、 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a v
14、ote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 6182-6 was prepared by Technical Committee ISO/TC 21, Equipment for fire protection and fire
15、 fighting, Subcommittee SC 5, Fixed firefighting systems using water. ISO 6182 consists of the following parts, under the general title Fire protection Automatic sprinkler systems: Part 1: Requirements and test methods for sprinklers Part 2: Requirements and test methods for wet alarm valves, retard
16、 chambers and water motor alarms Part 3: Requirements and test methods for dry pipe valves Part 4: Requirements and test methods for quick-opening devices Part 5: Requirements and test methods for deluge valves Part 6: Requirements and test methods for check valves Part 7: Requirements and test meth
17、ods for early suppression fast response (ESFR) sprinklers Part 8: Requirements and test methods for pre-action dry alarm valves Part 9: Requirements and test methods for water mist nozzles Part 10: Requirements and test methods for domestic sprinklers Part 11: Requirements and test methods for pipe
18、hangers Part 12: Requirements and test methods for grooved end pipe couplings Part 13: Requirements and test methods for extended coverage sprinklers Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for
19、 Resale, 04/19/2007 19:45:00 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 6182-6:2006(E) ISO 2006 All rights reserved v Introduction This part of ISO 6182 is one of a number of ISO International Standards prepared by ISO/TC 21 covering components for automatic sprink
20、ler systems, including the following: a) carbon dioxide systems (ISO 6183), b) explosion suppression systems (ISO 6184), An International Standard covering foam systems is planned. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical
21、 Standards 1/9972545001 Not for Resale, 04/19/2007 19:45:00 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/19/2
22、007 19:45:00 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 6182-6:2006(E) ISO 2006 All rights reserved 1 Fire protection Automatic sprinkler systems Part 6: Requirements and test methods for check valves 1 Scope This part of ISO 6182 specifies p
23、erformance requirements, methods of test and marking requirements for check valves used in automatic fire protection systems. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For un
24、dated references, the latest edition of the referenced document (including any amendments) applies. ISO 7-1, Pipe threads where pressure-tight joints are made on the threads Part 1: Designation, dimensions and tolerances ISO 37, Rubber, vulcanized or thermoplastic Determination of tensile stress-str
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 6182 2006
链接地址:https://www.31doc.com/p-3779118.html