ISO-3813-2004.pdf
《ISO-3813-2004.pdf》由会员分享,可在线阅读,更多相关《ISO-3813-2004.pdf(12页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 3813:2004(E) ISO 2004 INTERNATIONAL STANDARD ISO 3813 Third edition 2004-04-01 Resilient floor coverings Cork floor tiles Specification Revtements de sol rsilients Dalles en agglomr de lige Spcification Copyright International Organization for Standardization Provided by IHS un
2、der license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:13:28 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3813:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be
3、printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts n
4、o liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the fil
5、e is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form
6、or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47
7、 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2004 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:13:28 MDTNo reproduction or networking permitt
8、ed without license from IHS -,-,- ISO 3813:2004(E) ISO 2004 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out thro
9、ugh ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collabor
10、ates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of technical committees is to prepare International Standa
11、rds. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of t
12、his document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 3813 was prepared by the European Committee for Standardization as EN 12104 and was adopted, under a special “fast-track procedure”, by Technical Committee ISO/TC 87
13、, Cork, in parallel with its approval by the ISO member bodies. This third edition cancels and replaces the second edition (ISO 3813:1987), of which it constitutes a technical revision. In Clause 5, item a), “EN 12104:1999” has been replaced with “ISO 3813:2004”, for the purposes of international st
14、andardization. For the purposes of international standardization, a list of corresponding International and European Standards for which equivalents are not given in EN 12104 has been added as Annex ZZ. Copyright International Organization for Standardization Provided by IHS under license with ISO L
15、icensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:13:28 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3813:2004(E) iv ISO 2004 All rights reserved Page 2 EN 12104:2000 Foreword This European Standard has been prepared by Technical Committee CEN/TC 134 “Resili
16、ent and textile floor coverings“, the secretariat of which is held by BSI. This European Standard shall be given the status of a national standard, either by publication of an identical text or by endorsement, at the latest by November 2000, and conflicting national standards shall be withdrawn at t
17、he latest by November 2000. This European Standard has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association. This European Standard is considered to be a supporting standard to those application and product standards which in themselves suppor
18、t an essential safety requirement of a New Approach Directive and which make reference to this European Standard. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgium, Czech
19、Republic, Denmark, Finland, France, Germany, Greece, Iceland, Ireland, Italy, Luxembourg, Netherlands, Norway, Portugal, Spain, Sweden, Switzerland and the United Kingdom. This European Standard includes three informative annexes: Annex A: Optional properties Annex B: Supplementary information Annex
20、 C: Bibliography Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=Aramco HQ/9980755100 Not for Resale, 04/23/2007 03:13:28 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 3813:2004(E) ISO 2004 All rights reserved 1
21、 Page 3 EN 12104:2000 1 Scope This European Standard specifies the requirements for cork floor coverings made from agglomerated composition cork supplied in tile form which are designed to be used with a factory finish and/or an insitu finish. Cork floor coverings can be covered with other complemen
22、tary layers of decorative materials, e.g. decorative cork or wood veneers, with or without applied colours. This European Standard includes a classification system based on intensity of use which shows where cork floor tiles should give satisfactory service (see EN 685). It also specifies requiremen
23、ts for marking, labelling and packing. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated referen
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 3813 2004
链接地址:https://www.31doc.com/p-3779611.html