ISO-FDIS-9541-4-2009.pdf
《ISO-FDIS-9541-4-2009.pdf》由会员分享,可在线阅读,更多相关《ISO-FDIS-9541-4-2009.pdf(44页珍藏版)》请在三一文库上搜索。
1、 Please see the administrative notes on page iii RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORT- ING DOCUMENTATION. IN ADDITION TO THEIR EVALUATION AS BEING ACCEPTABLE FOR INDUSTRIAL, TECH
2、NO- LOGICAL, COMMERCIAL AND USER PURPOSES, DRAFT INTERNATIONAL STANDARDS MAY ON OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OF THEIR POTENTIAL TO BECOME STAN- DARDS TO WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS. Reference number ISO/IEC FDIS 9541-4:2009(E) ISO/IEC 2009 FINAL DRAFT ISO/IEC J
3、TC 1 Secretariat: ANSI Voting begins on: 2009-01-07 Voting terminates on: 2009-03-07 INTERNATIONAL STANDARD ISO/IEC FDIS 9541-4 Information technology Font information interchange Part 4: Harmonization to Open Font Format Technologies de linformation change dinformation sur les polices de caractres
4、Partie 4: Harmonisation au format de police de caractres ouvert Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=HP Monitoring/1111111164 Not for Resale, 02/02/2009 19:10:51 MSTNo reproduction or networking permitted without license from IHS -,
5、-,- ISO/IEC FDIS 9541-4:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the edi
6、ting. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be
7、 found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at
8、 the address given below. Copyright notice This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted under the applicable laws of the users country, neither this ISO draft nor any extract from it may be reproduced, stored in a retrieval system or tran
9、smitted in any form or by any means, electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office
10、 Case postale 56 CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators may be prosecuted. ii ISO/IEC 2009 All rights reserved Copyright International Organization for
11、Standardization Provided by IHS under license with ISO Licensee=HP Monitoring/1111111164 Not for Resale, 02/02/2009 19:10:51 MSTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC FDIS 9541-4:2009(E) ISO/IEC 2009 All rights reserved iii In accordance with the provisions of
12、 Council Resolution 21/1986, this document is circulated in the English language only. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=HP Monitoring/1111111164 Not for Resale, 02/02/2009 19:10:51 MSTNo reproduction or networking permitted with
13、out license from IHS -,-,- ISO/IEC FDIS 9541-4:2009(E) iv ISO/IEC 2009 All rights reserved Contents Page Foreword. v Introduction. vi 1 Scope 1 2 Normative references1 3 Terms and definitions .2 4 Harmonization to Open Font Format.2 4.1 Harmonization of the elements in OFF “head” table .2 4.2 Harmon
14、ization of the elements in OFF “name” table 5 4.3 Harmonization of the elements in OFF “hhea” table .6 4.4 Harmonization of the elements in OFF “hmtx” table.7 4.5 Harmonization of the elements in OFF “vhea” table8 4.6 Harmonization of the elements in OFF “vmtx” table .9 4.7 Harmonization of the elem
15、ents in OFF “maxp” table 10 4.8 Harmonization of the elements in OFF “kern” table10 4.9 Harmonization of the elements in OFF “post” table12 4.10 Harmonization of the elements in OFF “CFF” table.12 4.11 Harmonization of the elements in OFF “OS/2” table17 4.12 Harmonization of the elements in OFF “PCL
16、T” table 21 4.13 Harmonization of the elements in OFF “VORG” table.22 4.14 Harmonization of the elements in OFF “VDMX” table .23 5 Harmonization to the glyph names in OFF file .23 6 Layout Tag Registry and ISO/IEC 10036 .23 Annex A (informative) Harmonization of numerical properties to OFFS.24 A.1 G
17、eneral24 A.2 Comparison of the definitions of metric properties in OFFS and ISO/IEC 9541.24 A.2.1 Horizontal metric properties.24 A.2.2 Vertical metric properties .25 A.3 Harmonization of the numerical elements in OFF tables 26 A.3.1 Harmonization of the elements in OFF “head“ table26 A.3.2 Harmoniz
18、ation of the elements in OFF “hhea” table .26 A.3.3 Harmonization of the elements in OFF “hmtx” table.27 A.3.4 Harmonization of the elements in OFF “vhea” table28 A.3.5 Harmonization of the elements in OFF “vmtx” table .29 A.3.6 Harmonization of the elements in OFF “kern” table30 A.3.7 Harmonization
19、 of the elements in OFF “post“ table 30 A.3.8 Harmonization of the elements in OFF “CFF” table.31 A.3.9 Harmonization of the elements in OFF “OS/2” table31 A.3.10 Harmonization of the elements in OFF “PCLT” table 33 A.3.11 Harmonization of the elements in OFF “VORG” table.35 Bibliography36 Copyright
20、 International Organization for Standardization Provided by IHS under license with ISO Licensee=HP Monitoring/1111111164 Not for Resale, 02/02/2009 19:10:51 MSTNo reproduction or networking permitted without license from IHS -,-,- ISO/IEC FDIS 9541-4:2009(E) ISO/IEC 2009 All rights reserved v Forewo
21、rd ISO (the International Organization for Standardization) and IEC (the International Electrotechnical Commission) form the specialized system for worldwide standardization. National bodies that are members of ISO or IEC participate in the development of International Standards through technical co
22、mmittees established by the respective organization to deal with particular fields of technical activity. ISO and IEC technical committees collaborate in fields of mutual interest. Other international organizations, governmental and non-governmental, in liaison with ISO and IEC, also take part in th
23、e work. In the field of information technology, ISO and IEC have established a joint technical committee, ISO/IEC JTC 1. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The main task of the joint technical committee is to prepare Internationa
24、l Standards. Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting. Publication as an International Standard requires approval by at least 75 % of the national bodies casting a vote. Attention is drawn to the possibility that some of the
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO FDIS 9541 2009
链接地址:https://www.31doc.com/p-3780102.html