ISO-9184-3-1990.pdf
《ISO-9184-3-1990.pdf》由会员分享,可在线阅读,更多相关《ISO-9184-3-1990.pdf(8页珍藏版)》请在三一文库上搜索。
1、INTERNATIONAL STANDARD 9184-3 First edition 1990-12-15 Paper, board and pulps - Fibre furnish analysis - Part 3: Herzberg staining test Papier, carton et piites - Determination de la composition tibreuse - Partie 3: Coloration de Herzberg Reference number ISO 9184-3: 199O(E) Copyright International
2、Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/26/2007 19:23:32 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 9184-3:199O(E) Foreword ISO (the International Organization for Sta
3、ndardization) is a worldwide federation of national Standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Esch member body interested in a subject for which a technical committee has been established has the righ
4、t to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft Intern
5、ational Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an lnter- national Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 9184-3 was prepared by Technical Committee ISO/TC 6, Pap
6、er, board and pulps. ISO 9184 consists of the following Parts, under the general title Paper, board and pulps - Fibre furnish analysis: - Part 1: Genera/ method - Part 2: Staining guide - Part 3: Herzberg staining test - Part 4: Graff “C” staining test - Part 5: Lofton-Merritt staining test (modikat
7、ion of Wisbar) - Part 6: Weight factors by fibre coarseness method - Part 7: Weight factors by comparison method Part 1 gives general instructions for the Performance of frbre furnish analysis. lt should be used in conjunction with the staining guide (see part 2) and the staining tests (see Parts 3
8、to 5). Additional Parts of this International Standard will be published if re- quired by the development of new kinds of fibres or new staining tests. Annex A of this patt of ISO 9184 is for information only. 0 ISO 1990 All rights reserved. No part of this publication may be reproduced or utilized
9、in any ferm or by any means, electronie or mechanical, including photocopying and microfilm, without permisslon in writing from the publisher. International Organization for Standardization Case Postale 56 l CH-121 1 Geneve 20 l Switzerland Prlnted in Switzerland ii Copyright International Organizat
10、ion for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/26/2007 19:23:32 MDTNo reproduction or networking permitted without license from IHS -,-,- INTERNATIONAL STANDARD ISO 9184=3:1990(E) Paper, board and pulps - Fibre furnish
11、 analysis - Part 3: Herzberg staining test 1 Scope This patt of ISO 9184 specifies the preparation, use and colour reactions of Herzberg stain in fibre fur- nish analysis. lt should be used in conjunction with ISO 9184-1 and, if necessary, with other staining tests defined in ISO 9184-2. The Herzber
12、g staining test is applicable to the qualitative and quantitative differentiation between Chemical, mechanical and rag pulps. The stain also permits the qualitative identification of semi- Chemical pulp as weil as the differentiation between regenerated cellulose fibres (viscose, etc.) and syn- thet
13、ic fibres. 2 Normative reference The following Standard contains provisions which, through reference in this text, constitute provisions of this part of ISO 9184. At the time of publication, the edition indicated was valid. All Standards are subject to revision, and Parties to agreements based on th
14、is part of ISO 9184 are encouraged to investi- gate the possibility of applying the most recent edi- tion of the Standard indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 9184-13990, Paper, board and pulps - Fibre furnish analysis - Part 1: G
15、eneral method. 3 Principle Fibres are stained with Herzberg stain and exam- ined under the microscope. 4 Reagents CAUTION - Some of the components used in pre- paring this stafn are toxic. The stain should be pre- pared and handled in keeping with safe laboratory practice. Use only reagents of recog
16、nized analytical grade and distilled water or water of equivalent purity. 4.1 Zinc chloride Solution, saturated at room tem- perature. Add zinc chloride (ZnCl,) to about 100 ml of warm water until an undissolved residue remains. Allow to cool to room temperature and check that some zinc chloride cry
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 9184 1990
链接地址:https://www.31doc.com/p-3781596.html