NF-EN-12373-6-1999-ENG.pdf
《NF-EN-12373-6-1999-ENG.pdf》由会员分享,可在线阅读,更多相关《NF-EN-12373-6-1999-ENG.pdf(11页珍藏版)》请在三一文库上搜索。
1、NF EN 12373-6 janvier 1999 Ce document est usage exclusif et non collectif des clients Saga Web. Toute mise en rseau, reproduction et rediffusion, sous quelque forme que ce soit, mme partielle, sont strictement interdites. This document is intended for the exclusive and non collective use of Saga We
2、b customers. All network exploitation, reproduction and re-dissemination,even partial, whatever the form (hardcopy or other media), is strictly prohibited. Saga Web Pour THALES CORPORATE SERVICES SAS - EPM Client 04988312 le 16/7/2009 10:11 AFNOR 1999AFNOR 19991st issue 1999-01-P AFNOR 1999 All righ
3、ts reserved FE003600ISSN 0335-3931 NF EN 12373-6 January 1999 Classification index: A 91-455-6 European standard French standard Published and distributed by Association Franaise de Normalisation (AFNOR French standard institute) 11, avenue Francis de Pressens 93571 Saint-Denis La Plaine Cedex Tel.:
4、 + 33 (0)1 41 62 80 00 Fax: + 33 (0)1 49 17 90 00 www.afnor.fr ICS: 25.220.20; 77.120.10 Aluminium and aluminium alloys Anodizing Part 6: Assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid/chromic acid solution without prio
5、r acid treatment F : Aluminium et alliages daluminium Anodisation Partie 6 : valuation de la qualit des couches anodiques colmates par mesurage de la perte de masse aprs immersion en solution phosphochromique sans traitement acide pralable D : Aluminium und Aluminiumlegierungen Anodisieren Teil 6: P
6、rfung der Qualitt von verdichteten, anodisch erzeugten Oxidschichten durch Bestimmung des Masseverlustes nach Eintauchen in Chromphosphorsure-Lsung ohne vorherige Surebehandlung French standard approved by decision of the Director General of AFNOR on December 5, 1998 taking effect on January 5, 1999
7、. Replaces the approved standard NF A 91-416 dated June 1982. CorrespondenceThe European standard EN 12373-6:1998 has the status of French standard. Analysis. This document specifies a method for the assessment of quality of anodic oxidation coatings sealed on aluminium and its alloys by measurement
8、 of the loss of mass after immersion in phosphoric acid/chromic acid solution without prior acid treatment. Technical International Thesaurus: metal finishing, anodizing, aluminium, aluminium alloys, sealing, quality control, destructive tests, phosphoric acid, measurement, weight losses. Modificati
9、onsWith respect to document replaced, adoption of the European standard. Corrections EUROPEAN STANDARD NORME EUROPENNE EUROPISCHE NORM EN 12373-6 November 1998 ICS 25.220.20; 77.120.10 Descriptors:surface treatment, anodizing, aluminium, aluminium alloys, sealing, quality control, destructive tests,
10、 immersion tests, solution, phosphoric acid, measurements, mass losses English version Aluminium and aluminium alloys - Anodizing - Part 6: Assessment of quality of sealed anodic oxidation coatings by measurement of the loss of mass after immersion in phosphoric acid/chromic acid solution without pr
11、ior acid treatment Aluminium et alliages daluminium - Anodisation - Partie 6: Evaluation de la qualit des couches anodiques colmates par mesurage de la perte de masse aprs immersion en solution phosphochromique sans traitement acide pralable Aluminium und Aluminiumlegierungen - Anodisieren - Teil 6:
12、 Prfung der Qualitt von verdichteten, anodisch erzeugten Oxidschichten durch Bestimmung des Masseverlustes nach Eintauchen in Chromphosphorsure- Lsung ohne vorherige Surebehandlung This European Standard was approved by CEN on 5 November 1998. CEN members are bound to comply with the CEN/CENELEC Int
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- NF EN 12373 1999 ENG
链接地址:https://www.31doc.com/p-3788727.html