SAE-AIR-797E-1963-R2007.pdf
《SAE-AIR-797E-1963-R2007.pdf》由会员分享,可在线阅读,更多相关《SAE-AIR-797E-1963-R2007.pdf(15页珍藏版)》请在三一文库上搜索。
1、AEROSPACE INFORMATION REPORT AIR797 REV. E Issued1963-09 Revised1995-06 Reaffirmed2007-08 (R)Hose Characteristics and Selection Chart 1.SCOPE: This document lists military and industry specifications and standards which are used in aerospace systems and for ground servicing equipment. The characteri
2、stic limitations of the hose, which are of major importance to designers, and the sizes in which the hoses are standard are shown. Revisions and amendments, which are current for these specifications and standards, are not listed. 2.REFERENCES: The following publications form a part of this specific
3、ation to the extent specified herein. The latest issue of SAE publications shall apply. The applicable issue of other publications shall be the issue in effect on the date of the purchase order. In the event of conflict between the text of this specification and references cited herein, the text of
4、this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. Specific hose assembly (performance/procurement) specifications, bulk hose and assembly configuration standards are not listed in Sec
5、tion 2 but are the basis of the tables herein. 2.1SAE Publications: Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. AS150Hose Assembly, Type Classification of, Basic Performance and Fire/Resistance ARP600Torque Determination, Method of ARP603Impulse Test Equipment for Hydrauli
6、c System Components ARP605Routine Inspection and Test Procedure for Refueling Hoses AS611Tetrafluoroethylene Hose Assembly Cleaning Methods ARP908Hose Fitting, Installation and Qualification Test Torque Requirement AS1055Fire Testing of Flexible Hose, Tube Assemblies, Coils, Fittings and Similar Sys
7、tem Components AIR1377Fire Test Equipment for Flexible Tube and Hose Assemblies ARP1569Handling and Installation Practice for Aerospace Hose Assemblies RATIONALE This document has been reaffirmed to comply with the SAE 5-Year Review policy. SAE Technical Standards Board Rules provide that: “This rep
8、ort is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews ea
9、ch technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted
10、, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDR
11、ESS: http:/www.sae.org Copyright SAE International Provided by IHS under license with SAELicensee=Defense Supply Ctr/5913977001 Not for Resale, 12/04/2007 19:25:57 MSTNo reproduction or networking permitted without license from IHS -,-,- SAE AIR797 Revision E - 2 - 2.1 (Continued): ARP1658Visual Ins
12、pection Guide for Installed Hose Assemblies AIR1698Hose Assembly Identification Practices AS1933Age Controls for Hose Containing Age Sensitive Elastomeric Material AIR2000Aerospace Fluid System Standards, Metric National and International (Note: Provides Cross Reference AS/ARP to MA/ISO Documents fo
13、r Hose, Hose Assemblies, and Related Items) AIR4092Investigation of PTFE “Melt“ Phenomenon for High Pressure Hoses AIR4918Industry Practices and Guidelines for Selection of Coiled Tubes, Flex Hoses, Swivels and Extensive Fittings for Aircraft Fluid Systems 2.2U.S. Government Publications: Available
14、from DODSSP, Subscription Services Desk, Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094. MIL-H-6002Marking; Standard Hose, Aircraft MS33620Chart, Hose Selection MIL-STD-1523Age Controls of Age Sensitive Elastomeric Materials (Cancelled, see AS1933) 3.GENERAL: 3.1See Tables 1 through 4
15、for military and SAE hose assemblies and military and SAE hose protective sleeves. 3.2Classifications: 3.2.1AS150 lists most military specification and industry specification aerospace hose assemblies assigning a “universal“ type designation that may also be coded for fire resistance. Equivalency to
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SAE AIR 797 1963 R2007
链接地址:https://www.31doc.com/p-3792732.html