SAE-AS-4842-1-1995-R2007.pdf
《SAE-AS-4842-1-1995-R2007.pdf》由会员分享,可在线阅读,更多相关《SAE-AS-4842-1-1995-R2007.pdf(3页珍藏版)》请在三一文库上搜索。
1、AEROSPACE STANDARD AS4842/1 Issued1995-05 Reaffirmed2007-08 Fittings, 37 Flared to Pipe Threaded, Fluid Connection 1.SCOPE: 1.1Scope: This SAE Aerospace Standard (AS) establishes the requirements for fluid fittings that combine both 37 flared and pipe threaded connections for use in all types of flu
2、id systems. 1.2Classification: Fittings shall be furnished in the types and styles designated by the applicable AN, AS, MS, NAS, and other engineering standard drawings. This specification is the same as MIL-F-5509 as applicable to 37 flared to pipe threaded fittings except for updated materials and
3、 process specifications and industry coordinated general improvements. It is intended to serve as a procurement specification for the fittings described herein and in Section 6. 2.REFERENCES: 2.1Applicable Documents: The following publications form a part of this specification to the extent specifie
4、d herein. The latest issue of SAE publications shall apply. The applicable issue of other publications shall be the issue in effect on the date of the purchase order. In the event of conflict between the text of this specification and references cited herein, the text of this specification takes pre
5、cedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. 2.1.1SAE Publications: Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. AS4395Fitting End, External Thread, Flareless Design Standard AS484
6、1Fittings, 37 Flared, Fluid Connection AS4842Fittings and Bosses, Pipe Threaded, Fluid Connection RATIONALE This document has been reaffirmed to comply with the SAE 5-Year Review policy. SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of techni
7、cal and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which
8、 time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical,
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SAE AS 4842 1995 R2007
链接地址:https://www.31doc.com/p-3793464.html