SAE-AS-9434B-2003-R2007.pdf
《SAE-AS-9434B-2003-R2007.pdf》由会员分享,可在线阅读,更多相关《SAE-AS-9434B-2003-R2007.pdf(3页珍藏版)》请在三一文库上搜索。
1、 AEROSPACE STANDARD BOLT, TEE HEAD, CHAMFERED - CRES, UNS S66286, 130 KSI MIN, .3125-24 UNJF-3A AS9434 ISSUED 1998-10 REVISED 2003-09 REAFFIRMED 2007-06 THIRD ANGLE PROJECTION CUSTODIAN: SAE E-25 REV. B FEDERAL SUPPLY CLASS 5306 AS9434 SHEET 1 OF 3 REV. B THE INITIAL SAE PUBLICATION OF THIS DOCUMENT
2、 WAS TAKEN DIRECTLY FROM U.S. MILITARY STANDARD MS9434(ASG), AMENDMENT 1. THIS SAE STANDARD RETAINS THE SAME PART NUMBERS ESTABLISHED BY THE ORIGINAL MILITARY DOCUMENT. ANY REQUIREMENTS ASSOCIATED WITH QUALIFIED PRODUCTS LISTS (QPL) MAY CONTINUE TO BE MANDATORY FOR DOD CONTRACTS. REQUIREMENTS RELATI
3、NG TO QPLS HAVE NOT BEEN ADOPTED BY THE SAE FOR THIS STANDARD AND ARE NOT PART OF THIS SAE DOCUMENT. FIGURE 1 - BOLT SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely volun
4、tary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your wr
5、itten comments and suggestions. RATIONALE THIS DOCUMENT HAS BEEN REAFFIRMED TO COMPLY WITH THE SAE 5-YEAR REVIEW POLICY. Copyright 2007 SAE International All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, elec
6、tronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org Copyright SA
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SAE AS 9434 2003 R2007
链接地址:https://www.31doc.com/p-3793616.html