SDI-A250.3-1999.pdf
《SDI-A250.3-1999.pdf》由会员分享,可在线阅读,更多相关《SDI-A250.3-1999.pdf(16页珍藏版)》请在三一文库上搜索。
1、Test Procedure and Acceptance Criteria for Factory Applied Finish Painted Steel Surfaces for Steel Doors and Frames ANSI/SDI A250.3-1999 (R2003) Revision of ANSI A250.3-1993 ANSI/SDI A250.3-1999 STEEL DOOR INSTITUTE SPONSOR Steel Door Institute Approved February 4, 1999 ANSI/SDI A250.3-1999 (R2003)
2、Revision of ANSI/SDI A250.3-1993 American National Standard Test Procedure and Acceptance Criteria for Factory Applied Finish Painted Steel Surfaces for Steel Doors and Frames Approved February 4, 1999 American National Standards Institute, Inc. Secretariat Steel Door Institute American National Sta
3、ndard Approval of an American National Standard requires verification by ANSl that the requirements for due process, consensus, and other criteria for approval have been met by the standards developer. Consensus is established when, in the judgement of the ANSl Board of Standards Review, substantial
4、 agreement has been reached by directly and materially affected interests. Substantial agreement means much more than a simple majority, but not necessarily unanimity. Consensus requires that all views and objections be considered, and that a concerted effort be made toward their resolution. The use
5、 of American National Standards is completely voluntary; their exis- tence does not in any respect preclude anyone, whether they have approved the standards or not, from manufacturing, marketing, purchasing, or using products, processes, or procedures not conforming to the standards. The American Na
6、tional Standards Institute does not develop standards and will in no circumstances give any interpretation of any American National Standard. Moreover, no person shall have the right or authority to issue an interpretation of an American National Standard in the name of the American National Standar
7、ds Institute. Requests for interpretations should be addressed to the secretariat or sponsor whose name appears on the title page of this standard. CAUTION NOTICE: This American National Standard may be revised or withdrawn at any time. The procedures of the American National Stan- dards Institute r
8、equire that action be taken periodically to reaffirm, revise, or withdraw this standard. Purchasers of American National Standards may receive current information on all standards by calling or writing the American National Standards Institute. No part of this publication may be reproduced in any fo
9、rm, in an electronic retrieval system or otherwise, without prior written permission of the publisher. Printed in the United States of America ANSI/SDI A250.3-1999 Published by Steel Door Institute 30200 Detroit Road, Cleveland, Ohio 44145-1967 Copyright 2003 by Steel Door Institute All rights reser
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SDI A250 1999
链接地址:https://www.31doc.com/p-3794088.html