TIA-5150000-1986-R2002.pdf
《TIA-5150000-1986-R2002.pdf》由会员分享,可在线阅读,更多相关《TIA-5150000-1986-R2002.pdf(23页珍藏版)》请在三一文库上搜索。
1、The Teleconmiunications Industry Association represents the conmiunications sector of Copyright Telecommunications Industry Association Provided by IHS under license with EIALicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/29/2007 23:45:36 MDTNo reproduction or networking perm
2、itted without license from IHS -,-,- NOTICE TINEIA Engineering Standards and Publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in
3、selecting and obtaining with minimum delay the proper product for his particular need. Existence of such Standards and Publications shall not in any respect preclude any member or nonmember of TIA/EIA from manufacturing or selling products not conforming to such Standards and Publications, nor shall
4、 the existence of such Standards and Publications preclude their voluntary use by those other than TIA/EIA members, whether the standard is to be used either domestically or internationally. Standards and Publications are adopted by TIA/EIA in accordance with the American National Standards Institut
5、e (ANSI) patent policy. By such action, TIA/EIA does not assume any liability to any patent owner, nor does it assume any obligation whatever to parties adopting the Standard or Publication. TIA STANDARDS TIA Standards contain information deemed to be of technical value to the industry, and are publ
6、ished at the request of the originating Committee without necessarily following the rigorous public review and resolution of comments which is a procedural part of the development of a TIA/EIA Standard. TIA Standards should be reviewed on an annual basis by the formulating Committee and a decision m
7、ade on whether to proceed to develop a TIA/EIA Standard on this subject. TIA Standards must be cancelled by the Committee and removed from the TIA/EIA Standards Catalog before the end of their third year of existence. Publication of this TIA Standard for trial use and comment has been approved by th
8、e Telecommunications Industry Association. Distribution of this TIA Standard for comment shall not continue beyond 60 months from the date of publication. It is expected that following this 60 month period, this TIA Standard, revised as necessary, will be submitted to the American National Standards
9、 Institute for approval as an American National Standard. Suggestions for revision should be directed to: Standards - . 4 7 E I A 5150000 b m 3234600 O073052 T m EIA-5150000 Page 1 GENERIC SPECIFICATION FOR OPTICAL FIBER AND CABLE SPLICES (From EIA Standards Proposal No. 1562, formulated under the c
10、ognizance of the EIA FO-6.3 Subcommittee on Fiber Optic Interconnecting Devices . ) INTRODUCTION This Standard was formulated for the purpose of: (a) Promoting the interchangeability of splices (fiber and cable), and performance requirements. (b) Eliminating misunderstandings or confusion of product
11、 EIA Generic Specification EIA-5150000 applies to splices intended for use in optical waveguide communications. This EIA Generic Specification will be coordinated with the work of the IEC Subcommittee 86B on Fiber Optic Interconnecting Devices and Passive. Components. 1.0 SCOPE 1.1 This EIA Generic
12、Specification describes the mechanical and optical performance of optical fiber and optical cable splices used in optical waveguide communications, Excluded are splices unique to the fiber and cable manufacturing processes. Splices covered by this Specification join optical waveguide to optical wave
13、guide or join optical cable to optical cable or both. Optical waveguides joined may be made from glass, plastic, or a combination of both and may be the sizes as identified in EIA-458-Ah a Copyright Telecommunications Industry Association Provided by IHS under license with EIALicensee=IHS Employees/
14、1111111001, User=Wing, Bernie Not for Resale, 03/29/2007 23:45:36 MDTNo reproduction or networking permitted without license from IHS -,-,- I E I A 5150000 8b M 3234600 0073053 1 c EIA-5150000 Page 2 Splice subfamilies shall be described in Sectional Specifications that will reference this Generic S
15、pecification. A Blank Detail Specification, from which a splice manufacturer may develop a Detail Specification by filling in performance data on his product, will reference a corresponding Sectional Specification. Splices covered by this Specification fall into two general environmental categories
16、Of protected environment splices, and non-protected environment splices. Splices can be permanent or semi-permanent. Definitions of these terms are found in paragraph 2.3. 1.2 Classifica tion The following classifications are intended to aid in fully describing a splice in a Sectional or Detail Spec
17、ification. Additional terms may be used, if needed. Fiber Splice Cable Structure Splice or Splice Closure Cable Splice Hybrid Splice Definitions for these terms may be found in paragraph 2.3. 2.0 GENERAL 2.1 Related Documents The following documents of the issue in effect form a part of this Specifi
18、cation to the extent specified herein. 2.1.1 Electronic Industries Association (EIA) 2001 Eye Street N.W. Washington, D.C. 20006 EIA-440 Fiber Optic Terminology (May, 1978) EIA-455 Standard Test Procedures for Fiber Optic Fibers, Cables, Transducers, Connecting and Terminating Devices (March, 198pI)
19、 Copyright Telecommunications Industry Association Provided by IHS under license with EIALicensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/29/2007 23:45:36 MDTNo reproduction or networking permitted without license from IHS -,-,- 7 - E .EIA 5150000 8b m 3234600 0073054 3 = EIA-
20、 51 5 0 00 0 Page 3 E IA- 4 55 Addendums (see Note 1 following E IA- 4 5 8-A EIA-476 Standard Optical Waveguide Fiber Material Classes and Preferred Sizes (June, 1984) Source and Date Code Marking (April, 1981) 2.1.2 American Society for Testing and Materials 1916 Race Street Philadelphia, PA 19103
21、ASTM G 21 Determining Resistance of Synthetic Polymeric Materials to Fungi 2.1.3 American National Standards Institute (ANSI) 1430 Broadway New York, NY 10018 ANSI/ASQC 21.4-1981 Sampling Pr qced ur es and Tables for Inspection by Attributes (ANSI/MIL-STD-105) (IEC Publication 410) Electrical and El
22、ectronics Diagrams ANSI/IEEE-315-1975 Graphic Symbols for ANSI/IEEE-200-1975 Reference Designations for Electrical and Electronics Parts and Equipment ANSI 2136.1-1980 Safe Use of Lasers ANSI/ IEEE-100-19 84 Standard Dictionary of Electrical and Electronic Terms ANSI/IEEE-260-1978 Letter Symbols for
23、 SI Units and Certain other Units of Measurement NOTE 1: Some of the FOTPs listed in Table 1 and in various paragraphs of this Specification may not be presently included in EIA-455 and its Addendums, but are under development. Accordingly, only published FOTPs can be considered to be re.quirements
24、of this Standard. When this Standard is referenced as part of a DoD-initiated contract, refer to the DoD Acceptance Notice for special DoD requirements. Copyright Telecommunications Industry Association Provided by IHS under license with EIALicensee=IHS Employees/1111111001, User=Wing, Bernie Not fo
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- TIA 5150000 1986 R2002
链接地址:https://www.31doc.com/p-3800926.html