CEA-633.34-1997.pdf

CEA Standard Infrared Physical Layer Conformance ANSI/CEA-633.34 October 1997 Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- NOTICE CEA Standards, Bulletins and other technical publications are designed to serve the public interest through eliminating misunderstandings between manufacturers and purchasers, facilitating interchangeability and improvement of products, and assisting the purchaser in selecting and obtaining with minimum delay the proper product for his particular need. Existence of such Standards, Bulletins and other technical publications shall not in any respect preclude any member or nonmember of CEA from manufacturing or selling products not conforming to such Standards, Bulletins or other technical publications, nor shall the existence of such Standards, Bulletins and other technical publications preclude their voluntary use by those other than CEA members, whether the standard is to be used either domestically or internationally. Standards, Bulletins and other technical publications are adopted by CEA in accordance with the American National Standards Institute (ANSI) patent policy. By such action, CEA does not assume any liability to any patent owner, nor does it assume any obligation whatever to parties adopting the Standard, Bulletin or other technical publication. This CEA Standard is considered to have International Standardization implication, but the International Electrotechnical Commission activity has not progressed to the point where a valid comparison between the CEA Standard and the IEC document can be made. This Standard does not purport to address all safety problems associated with its use or all applicable regulatory requirements. It is the responsibility of the user of this Standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before its use. (From Project Number 3898, formulated under the cognizance of the CEA R7 Home Networks Committee.) Published by CONSUMER ELECTRONICS ASSOCIATION 2002 Technology & Standards Department 2500 Wilson Boulevard Arlington, VA 22201 PRICE: Please call Global Engineering Documents, USA and Canada (1-800-854-7179) International (303-397-7956), or http:/global.ihs.com All rights reserved Printed in U.S.A. Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- PLEASE! DON”T VIOLATE THE LAW! This document is copyrighted by CEA and may not be reproduced without permission. Organizations may obtain permission to reproduce a limited number of copies through entering into a license agreement. For information, contact: Global Engineering Documents 15 Inverness Way East Englewood, CO 80112-5704 or call U.S.A. and Canada 1-800-854-7179, International (303) 397-7956 See http:/global.ihs.com or email globalihs.com Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA-633.34 INFRARED PHYSICAL LAYER CONFORMANCE CONTENTS 1. Introduction. .1 2. Test Specification1 2.1. Test Cases. .1 2.2. Test Steps.4 2.3. Test Case Dynamic Behavior4 i Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA-633.34 1. Introduction. This portion of the conformance standard specifies tests to determine conformance of a Node's IR Physical Layer to IS-60. Part One of this standard provides an overview of the conformance philosophy. The reader is urged to review that material before attempting to use the details provided in this part. Three subsections under the following Test Specification heading provide Test Cases, Test Steps, and Test Case Dynamic Behavior, respectively. Test Cases are a terse description of each test to be run on a Unit Under Test (UUT). Test Steps are the building blocks for Test Cases. Test Case Dynamic Behavior is the formal expansion of each Test Case, written in the form of a series of Test Steps with a Pass or Fail outcome. 2. Test Specification. 2.1. Test Cases. This section provides the test cases for the IR Physical Layer test suite. Test cases are presented in a table format. The first column provides the purpose of the test case. The next two columns provide the test case identifier and cross-reference (section number in IR Physical Layer and Media of IS-60) respectively. The last column gives the page number of the test case dynamic behavior (test case expansion). Tests that derive from mandatory Physical Layer requirements are marked with “ “ in the Description column and are to be performed on all UUTs. Tests shall be conducted in an environment such that repeatable results can be obtained. It is recommended that the IR test medium be isolated in a blackout room or other suitable location. Date, time, location, and other pertinent information shall be recorded. 1 Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA-633.34 Test Suite Overview Suite Name: IR Standards Reference: IS-60 PICS Proforma Reference: PIXIT Proforma Reference: Test Method: Remote Single Layer Embedded (Incremental) Comments: Test Suite for testing IR Physical Layer Description Test Case ID Test Case Reference Page Verify that the symbol timing width meets the ± 5-microsecond tolerance IR1_1 4.5.3.15 Verify that the UUT IR output power is greater than 60 mW/sr within the band 800-950 nm. IR1_2 4.5.4.1.25 Verify that the UUT IR output power is less than 10 mW/sr outside the band 750-1050 nm. IR1_3 4.5.4.1.26 Verify that the IR output power (on the central axis of the IR beam) while in the Inferior state is less than .01 µW/sr. IR1_4 4.5.4.26 Verify that the subcarrier frequency is 100 kHz ± 0.5%. IR1_5 4.5.3.1.26 Verify that the IR wavelength is in the range 850-1000 nm. IR1_6 4.5.3.1.2 7 Verify that the carrier on time (Ton) is between 2.50 and 5.00 microseconds. IR1_7 4.5.3.1.27 Verify that a Superior state is encoded with a multiple of 10 IR pulses. IR1_8 All 8 Verify that a Superior state is detected if a 100 kHz (± 0.5%) IR subcarrier in the band of 850-1000 nm is received with an E 0.15 µW/cm2 and remains 0.15 µW/cm2 for a minimum of 20 microseconds. IR1_9 4.5.5.18 2 Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA-633.34 Description Test Case ID Test Case Reference Page Verify that an Inferior state is detected if a 100 kHz (± 0.5%) IR subcarrier in the band of 850-1000 nm is received with an E 105) F Bad timing on 1 END_IF MEASURE_TIME(ZERO) IF (TIME 205) F Bad timing on 0 END_IF MEASURE_TIME(EOF) IF (TIME 305) F Bad timing on EOF END_IF MEASURE_TIME(EOP) IF (TIME 405) F Bad timing on EOP ELSE P END_IF Test Case Dynamic Behavior Reference: 4.5.4.1.2 Identifier: IR1_2 Purpose: Verify that the UUT IR output power is greater than 60 mW/sr within the band 800-950 nm. Behavior Description V Comments UUT_TRANSMIT MEASURE_Ie(Superior) IF (Ie 10 mW/sr) F Output is too high ELSE P END_IF Test Case Dynamic Behavior Reference: 4.5.4.2 Identifier: IR1_4 Purpose: Verify that the IR output power (on the central axis of the IR beam) while in the Inferior state is less than .01 W/sr. Behavior Description V Comments UUT_TRANSMIT MEASURE_Ie(Inferior) IF (Ie 10 mW/sr) F Output is too high ELSE P END_IF Test Case Dynamic Behavior Reference: 4.5.3.1.2 Identifier: IR1_5 Purpose: Verify that the subcarrier frequency is 100 kHz 0.5%. Behavior Description V Comments UUT_TRANSMIT MEASURE_SUBCARRIER IF (99.5 kHz 5.00) F Bad timing on subcarrier pulse ELSE P END_IF 7 Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA-633.34 Test Case Dynamic Behavior Reference: All Identifier: IR1_8 Purpose: Verify that a Superior state is encoded with a multiple of 10 IR pulses. Behavior Description V Comments UUT_TRANSMIT COUNT_PULSES(ONE) IF (COUNT 10) F Incorrect pulse count on 1 END_IF COUNT_PULSES(ZERO) IF (COUNT 20) F Incorrect pulse count on 0 END_IF COUNT_PULSES(EOF) IF (COUNT 30) F Incorrect pulse count on EOF END_IF COUNT_PULSES(EOP) IF (COUNT 40) F Incorrect pulse count on EOP ELSE P END_IF Test Case Dynamic Behavior Reference: 4.5.5.1 Identifier: IR1_9 Purpose: Verify that a Superior state is detected if a 100 kHz ( 0.5%) IR subcarrier in the band of 850-1000 nm is received with an E 0.15 W/cm2 and remains 0.15 W/cm2 for a minimum of 20 microseconds. Behavior Description V Comments TRANSMIT_FRAME(0.15 µW/cm2) Superior at 0.15 µW/cm2 WAIT UUT_RECEIVE P TIMER_EXPIRED F Frame not received This test does not check for minimum state recognition time (20 microseconds). 8 Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA-633.34 Test Case Dynamic Behavior Reference: 4.5.5.2 Identifier: IR1_10 Purpose: Verify that an Inferior state is detected if a 100 kHz ( 0.5%) IR subcarrier in the band of 850-1000 nm is received with an E 0.15 nW/cm2 and remains 0.15 nW/cm2 for a minimum of 20 microseconds. Behavior Description V Comments TRANSMIT_FRAME(0.15 nW/cm2) Inferior at 0.15 nW/cm2 WAIT UUT_RECEIVE P TIMER_EXPIRED F Frame not received This test does not check for minimum state recognition time (20 microseconds). Test Case Dynamic Behavior Reference: 4.5.5.2 Identifier: IR1_11 Purpose: Verify interfering signal rejection for the UUT control channel receiver. Behavior Description V Comments GENERATE_INTERFERENCE TRANSMIT_FRAME Transmit good frame WAIT UUT_RECEIVE P TIMER_EXPIRED F Bad interference rejection Reference: 4.5.6.2 Identifier: IR1_12 Purpose: Review manufacturer data to confirm that jabber inhibit capability is present. Behavior Description V Comments Self explanatory. 9 Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- CEA Document Improvement Proposal If in the review or use of this document, a potential change is made evident for safety, health or technical reasons, please fill in the appropriate information below and email, mail or fax to: Consumer Electronics Association Technology & Standards Department 2500 Wilson Blvd. Arlington, VA 22201 FAX: 703 907-7693 standardsce.org Document No. Document Title: Submitters Name: Telephone No.: Submitters Company: FAX No.: e-mail: Address: Urgency of Change: Immediate: At next revision: Problem Area: a. Clause Number and/or Drawing: b. Recommended Changes: c. Reason/Rationale for Recommendation: Additional Remarks: Signature: Date: FOR CEA USE ONLY Responsible Committee: Chairman: Date comments forwarded to Committee Chairman: Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright Consumer Electronics Association Provided by IHS under license with CEA Licensee=IHS Employees/1111111001, User=Wing, Bernie Not for Resale, 03/30/2007 21:45:42 MDTNo reproduction or networking permitted without license from IHS -,-,-