BS EN 61280-4-1-2009 纤维光学通信子系统试验程序.安装的光缆设备.多模衰减测量.pdf
《BS EN 61280-4-1-2009 纤维光学通信子系统试验程序.安装的光缆设备.多模衰减测量.pdf》由会员分享,可在线阅读,更多相关《BS EN 61280-4-1-2009 纤维光学通信子系统试验程序.安装的光缆设备.多模衰减测量.pdf(66页珍藏版)》请在三一文库上搜索。
1、- - - Fibre optic communication subsystem test procedures Part 41: Installed cable plant Multimode attenuation measurement BS EN 61280-4-1:2009 - - National foreword This British Standard is the UK implementation of EN 61280-4-1:2009. It is identical to IEC 61280-4-1:2009. It supersedes BS EN 61280-
2、4-1:2004 which is withdrawn. The UK participation in its preparation was entrusted by Technical Committee GEL/86, Fibre optics, to Subcommittee GEL/86/3, Fibre optic systems and active devices. A list of organizations represented on this committee can be obtained on request to its secretary. This pu
3、blication does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. BSI 2010 ISBN 978 0 580 57326 2 ICS 33.180.01 Compliance with a British Standard cannot confer immunity from legal obligations. This British Standard was published und
4、er the authority of the Standards Policy and Strategy Committee on 31 January 2010 Amendments issued since publication Amd. No. Date Text affected BRITISH STANDARDBS EN 61280-4-1:2009 - - EUROPEAN STANDARD EN 61280-4-1 NORME EUROPENNE EUROPISCHE NORM December 2009 CENELEC European Committee for Elec
5、trotechnical Standardization Comit Europen de Normalisation Electrotechnique Europisches Komitee fr Elektrotechnische Normung Central Secretariat: Avenue Marnix 17, B - 1000 Brussels 2009 CENELEC - All rights of exploitation in any form and by any means reserved worldwide for CENELEC members. Ref. N
6、o. EN 61280-4-1:2009 E ICS 33.180.01 Supersedes EN 61280-4-1:2004 English version Fibre optic communication subsystem test procedures - Part 4-1: Installed cable plant - Multimode attenuation measurement (IEC 61280-4-1:2009) Procdures dessai des sous-systmes de tlcommunication fibres optiques - Part
7、ie 4-1: Installation cble - Mesure de laffaiblissement en multimodal (CEI 61280-4-1:2009) Prfverfahren fr Lichtwellenleiter- Kommunikationsuntersysteme - Teil 4-1: Lichtwellenleiter-Kabelanlagen - Mehrmoden-Dmpfungsmessungen (IEC 61280-4-1:2009) This European Standard was approved by CENELEC on 2009
8、-10-01. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be o
9、btained on application to the Central Secretariat or to any CENELEC member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the C
10、entral Secretariat has the same status as the official versions. CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Cyprus, the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg
11、, Malta, the Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. BS EN 61280-4-1:2009 - - EN 61280-4-1:2009 - 2 - Foreword The text of document 86C/879/FDIS, future edition 2 of IEC 61280-4-1, prepared by SC 86C, Fibre optic systems
12、and active devices, of IEC TC 86, Fibre optics, was submitted to the IEC-CENELEC parallel vote and was approved by CENELEC as EN 61280-4-1 on 2009-10-01. This European Standard supersedes EN 61280-4-1:2004. The main changes with respect to EN 61280-4-1:2004 are listed below: an additional measuremen
13、t method based on optical time domain reflectometry (OTDR) is documented, with guidance on best practice in using the OTDR and interpreting OTDR traces; the requirement for the sources used to measure multimode fibres is changed from one based on coupled power ratio (CPR) and mandrel requirement to
14、one based on measurements of the near field at the output of the launching test cord; highlighting the importance of, and giving guidance on, good measurement practices including cleaning and inspection of connector end faces. The following dates were fixed: latest date by which the EN has to be imp
15、lemented at national level by publication of an identical national standard or by endorsement (dop) 2010-07-01 latest date by which the national standards conflicting with the EN have to be withdrawn (dow) 2012-10-01 Annex ZA has been added by CENELEC. _ Endorsement notice The text of the Internatio
16、nal Standard IEC 61280-4-1:2009 was approved by CENELEC as a European Standard without any modification. In the official version, for Bibliography, the following notes have to be added for the standards indicated: IEC 60793-1-40 NOTE Harmonized as EN 60793-1-40:2003 (modified). IEC 60793-2 NOTE Harm
17、onized as EN 60793-2:2008 (not modified). IEC 60793-2-10 NOTE Harmonized as EN 60793-2-10:2007 (not modified). IEC 60793-2-50 NOTE Harmonized as EN 60793-2-50:2008 (not modified). IEC 61300-3-6 NOTE Harmonized as EN 61300-3-6:2009 (not modified). _ BS EN 61280-4-1:2009 - - - 3 - EN 61280-4-1:2009 An
18、nex ZA (normative) Normative references to international publications with their corresponding European publications The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edi
19、tion of the referenced document (including any amendments) applies. NOTE When an international publication has been modified by common modifications, indicated by (mod), the relevant EN/HD applies. Publication Year Title EN/HD Year IEC 60825-2 -1) Safety of laser products - Part 2: Safety of optical
20、 fibre communication systems (OFCS) EN 60825-2 20042) IEC 61280-1-3 -3) Fibre optic communication subsystem test procedures - Part 1-3: General communication subsystems - Central wavelength and spectral width measurement EN 61280-1-3 -3) IEC 61280-1-4 -1) Fibre optic communication subsystem test pro
21、cedures - Part 1-4: General communication subsystems - Light source encircled flux measurement method EN 61280-1-4 200X4) IEC/PAS 61300-3-35 -1) Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Fibre optic
22、 cylindrical connector endface visual inspection - - IEC 61315 -1) Calibration of fibre-optic power meters EN 61315 20062) IEC 61745 -1) End-face image analysis procedure for the calibration of optical fibre geometry test sets - - IEC 61746 -1) Calibration of optical time-domain reflectometers (OTDR
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- BS EN 61280-4-1-2009 纤维光学通信子系统试验程序.安装的光缆设备.多模衰减测量 61280 2009 纤维光学 通信 子系统 试验 程序 安装 光缆 设备 衰减 测量
链接地址:https://www.31doc.com/p-3647911.html