FORD-ESE-M2P128-A-2000.pdf
《FORD-ESE-M2P128-A-2000.pdf》由会员分享,可在线阅读,更多相关《FORD-ESE-M2P128-A-2000.pdf(4页珍藏版)》请在三一文库上搜索。
1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2000 11 29 Revised Updated and Renumbered A. Cockman 1996 08 12 Revised Updated and no rust, corrosion creepage or loss of adhesion more than 3.2 mm from the scribe lines, sharp edges or around holes. 3.4.3
2、Gasoline Resistance Shall not blister or show more than slight softening or dulling when subjected to immersion in M-14J148-A (shown on M-14J100A), Petroleum Naphtha, for 1 h at 23 +/- 2 C. ENGINEERING MATERIAL SPECIFICATION ESE-M2P128-A Page 3 of 4 Copyright 2000, Ford Global Technologies, Inc. 3.4
3、.4 Hot Oil Resistance Shall not blister or show more than slight softening or dulling when subjected to immersion in hot (66 +/- 3 C) initial fill engine oil for 1 h. 3.4.5 Ethylene Glycol Resistance Shall not blister or show more than slight softening or dulling when subjected to immersion for 1 h
4、at 23 +/- 2 C in a solution of 50 % water and 50 % initial fill Long Life Coolant Concentrate. 3.4.6 Heat Resistance (FLTM BI 106-01, Part A) Heat in an oven at 205 +/- 3 C for 1 h. Upon removal, test for adhesion to classification Grade 0. No chipping, flaking or cracking. 3.5 INFRARED SPECTROPHOTO
5、METRY AND/OR THERMAL ANALYSIS IR spectra and thermograms established for initial approval shall constitute the reference standard and shall be kept on file at the designated material laboratory. All samples shall produce IR spectra and thermograms that correspond to the reference standard when teste
6、d under the same conditions. 3.6 TEST PANELS (ASTM D 609) It may not be feasible to test painted parts under this specification for film and durability properties. Standard laboratory panels may be used only if authorized by Divisional Quality Control. The finished panels must be representative of p
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- FORD ESE M2P128 2000
链接地址:https://www.31doc.com/p-3756208.html