ISO-22774-2004.pdf
《ISO-22774-2004.pdf》由会员分享,可在线阅读,更多相关《ISO-22774-2004.pdf(14页珍藏版)》请在三一文库上搜索。
1、 Reference number ISO 22774:2004(E) ISO 2004 INTERNATIONAL STANDARD ISO 22774 First edition 2004-12-01 Footwear Test methods for accessories: shoe laces Abrasion resistance Chaussures Mthodes dessai pour accessoires: lacets et illets Rsistance labrasion Copyright International Organization for Stand
2、ardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/22/2007 07:41:31 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22774:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance
3、with Adobes licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobes licensin
4、g policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. E
5、very care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ISO 2004 All rights reserved. Unless otherwise specified, no part of this publica
6、tion may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISOs member body in the country of the requester. ISO copyright office Case postale 56 CH-1211 Geneva
7、20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO 2004 All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resa
8、le, 04/22/2007 07:41:31 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22774:2004(E) ISO 2004 All rights reserved iii Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work
9、of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-government
10、al, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2. The mai
11、n task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Att
12、ention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. ISO 22774 was prepared by the European Committee for Standardization (CEN) in collaboration with Technic
13、al Committee ISO/TC 216, Footwear, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). Throughout the text of this document, read “.this European Standard.” to mean “.this International Standard.”. Annex ZA provides a list of corresponding International
14、and European Standards for which equivalents are not given in the text. Copyright International Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/22/2007 07:41:31 MDTNo reproduction or networking permitted withou
15、t license from IHS -,-,- ISO 22774:2004(E) iv ISO 2004 All rights reserved Contents Page Forewordv 1 Scope 1 2 Normative references 1 3 Terms and definitions .1 4 Principle1 5 Apparatus and materials.2 5.1 General2 6 Test specimens4 6.1 Method 1 .4 6.2 Methods 2 and 3.4 7 Conditioning.4 8 Procedure
16、.4 8.1 Method 1 .4 8.2 Method 2 .5 8.3 Method 3 .5 9 Calculation and expression of results.5 10 Test report 6 Annex ZA (normative) Normative references to International publications with their corresponding European publications7 5.2 Standard eyelets3 5.3 Six test lace carriers.3 Copyright Internati
17、onal Organization for Standardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/22/2007 07:41:31 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22774:2004(E) ISO 2004 All rights reserved v Foreword This doc
18、ument (EN ISO 22774:2004) has been prepared by CEN/TC 309, “Footwear“, the secretariat of which is held by AENOR, in collaboration with Technical Committee ISO/TC 216 “Footwear“. This European Standard shall be given the status of a national standard, either by publication of an identical text or by
19、 endorsement, at the latest by June 2005, and conflicting national standards shall be withdrawn at the latest by June 2005. According to the CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to implement this European Standard: Austria, Belgi
20、um, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, Switzerland and United Kingdom. Copyright International Organization for S
21、tandardization Provided by IHS under license with ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/22/2007 07:41:31 MDTNo reproduction or networking permitted without license from IHS -,-,- Copyright International Organization for Standardization Provided by IHS under license wi
22、th ISO Licensee=NASA Technical Standards 1/9972545001 Not for Resale, 04/22/2007 07:41:31 MDTNo reproduction or networking permitted without license from IHS -,-,- ISO 22774:2004(E) ISO 2004 All rights reserved 1 1 Scope This document specifies three test methods for determining the abrasion resista
23、nce of a shoe lace to repeated rubbing: Method 1: lace to lace abrasion; Method 2: lace to standard eyelet abrasion; Method 3: lace to eyelet (from footwear) abrasion. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated referenc
24、es, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. EN 12222, Footwear Standard atmospheres for conditioning and testing of footwear and components for footwear 3 Terms and definitions For the purposes of this
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ISO 22774 2004
链接地址:https://www.31doc.com/p-3776488.html